ABS Golf Cart Body: Formed Shell

Resort fleets are judged by colour consistency. Six new carts that read a shade off the original twelve look worse than a fleet with a few scratched bodies, and that is why ABS golf cart body supply is usually a colour matching exercise before it is a forming exercise.

The shells themselves are straightforward vacuum forms. The difficulty is repeatability: a 5 mm body shell 1.2 m long has to come off the tool with the same wall thickness at the front and rear corners over a run of hundreds.

Forming an ABS golf cart body shell

  • Fenders and trim: 4 mm ABS
  • Main body: 5 mm ABS, UV stabilised
  • Draw ratio at the nose: about 1.6, needs a heated tool
  • Colour: painted or capped, matched to a master panel
ABS golf cart body shell being assembled on a chassis

The nose is the deep draw and the place where thickness falls. A 5 mm sheet at a 1.6 draw ratio finishes around 3.6 mm at the front, which is still adequate for impact but shows on a thickness check. Tool temperature control is what keeps that figure consistent.

Colour, gloss and the ABS golf cart body in a fleet

Painted shells match a master panel exactly and can be resprayed after a collision. Capped or pre coloured sheet is cheaper per unit but a later batch can drift by a shade, which is visible when carts park in a row.

Keeping a rental fleet presentable

Most fleet damage is low speed contact with bag stands and kerbs. ABS holds up to that better than a thin polypropylene shell, and small dents can be warmed and pushed back. Deep tears are repaired with a hot air weld and a respray, which is cheaper than replacing the body.

River People forms ABS body shells to your cart model with UV stabilised sheet and colour matched to a supplied panel. Send the model and fleet size to oversales@rpplexiglass.com.

Send your cart model, colour reference and fleet quantity to oversales@rpplexiglass.com for a quotation on formed body shells.

Deep draws at the nose are where shell thickness varies, and the ABS vacuum forming draw guide explains planning draw ratio against starting gauge.

Frequently Asked Questions

Does ABS survive outdoor UV on a golf course?

Standard ABS chalks in two summers. UV stabilised grade with a painted or capped surface holds colour for five years or more.

What thickness for a body shell?

4 mm for fenders and small panels, 5 mm for the main body where a bag or club can strike it.

Can shells be supplied pre coloured?

Yes, in a limited palette. Painted shells give exact fleet colour match, which matters when a resort adds six carts to an existing set.