Acrylic Beer Tap Display: Bar Top

Acrylic beer tap display units sit at the busiest point of a bar, where a wet glass is put down beside them twenty times an hour, and the failure that ends their life is usually water inside the light box.

A brewery chain in Barcelona replaced fourteen tap displays in one year. The print had not faded; condensate from cold beer had reached the LED strip and the units went dark from the bottom up.

Light box depth in an acrylic beer tap display

Backlight spacing that removes hot spots

  • Case depth: 45 mm for a diffused face
  • LED pitch: 40 mm with a diffuser sheet
  • Face panel: 5 mm printed, 10 mm structural
  • Seal: gasket plus drain notch

A face panel close to a bare strip shows individual LEDs, which reads as a cheap sign. A 45 mm case with a diffuser spreads the light evenly, and the extra depth is also where the gasket and drain sit.

Spill, seal and cleaning

acrylic beer tap display on a bar top with illuminated branding

A drain notch at the low corner lets any liquid out instead of pooling against the seal. Combined with a closed cell gasket, that detail is the difference between a display that lasts three years and one that fails in a season.

Print and brand changes

Brands change artwork more often than they change hardware. A face panel that slides out of the case lets a bar keep the case and swap the print, which is how the units are specified on multi outlet contracts.

Light box panel construction is covered in acrylic LED light box guide.

Send your tap layout, brand artwork and bar count to oversales@rpplexiglass.com for a quotation.

Frequently Asked Questions

Which thickness for a bar top display?

5 mm for a printed face panel, 10 mm where the display also mounts the tap itself and takes the pull load.

How is the light box kept dry?

A sealed case with a gasket and a drain path, not just a printed panel in front of a strip. Beer spilt on a bar top finds every gap within a season.

Can a printed panel be replaced alone?

Yes, if the print sits on a separate face panel that slides out of the case. A display built as one sealed block has to be replaced whole for a brand change.