Walk into any good bakery and the acrylic cloche dome is doing two jobs at once: showing the pastry and keeping it clean. Nothing else on the counter has to be both transparent and protective at the same time.
The buyer question that arrives most often is not about clarity. It is about the crown going soft and wavy after a few months of dishwashing, which is a forming problem and not a material problem.
Forming an acrylic cloche dome without thin walls
The dome is drape formed over a male mould. The sheet is heated to 150 to 170 C, pulled down over the mould and held there while it cools. If the sheet is released hot, the crown relaxes back and the dome loses height.
- Diameter 250 mm: 3 mm, height 130 mm
- Diameter 300 mm: 3 mm, height 150 mm
- Diameter 400 mm: 5 mm, height 190 mm
- Base: 6 mm plate with a 6 mm groove to locate the dome
Thickness at the crown falls to about 70 percent of the starting gauge on a deep draw. That is normal and acceptable. What is not acceptable is a cold mould, which freezes the sheet before it touches down and leaves a wall that varies by 30 percent around the circumference.
Base, knob and the acrylic cloche dome in service
The base is the part that gets handled, so it is 6 mm rather than 3 mm. A shallow groove locates the dome and stops it sliding when a customer lifts it by the knob with one hand.
Knobs are turned from 10 mm offcuts and bonded with a two part adhesive. A knob screwed through the crown pulls a stress ring into the clearest part of the dome, and that ring shows as a rainbow under counter light.
Cleaning that does not craze the dome
Hot water above 70 C plus a strong detergent is the usual cause of crazing on the inside face. Wash at 40 to 50 C with neutral soap, rinse and air dry upside down. Commercial dishwashers are out.
We form cloches in Anqing to the diameter and height you specify, with the base groove matched to the dome. Send the counter plan or a simple sketch to oversales@rpplexiglass.com for a quotation.
Send the dome diameter, height and base style to oversales@rpplexiglass.com for a quotation on formed cloches.
Counters carrying a dome almost always carry a stand, and the acrylic cake stand build sets out the base and tier sizes that pair with a 300 mm cloche.
Frequently Asked Questions
What thickness is a 300 mm cloche dome formed from?
3 mm up to 300 mm diameter, 5 mm above that. A 400 mm dome at 3 mm collapses slightly at the crown after repeated washing.
How is the dome formed?
Cast acrylic is drape formed over a male mould at 150 to 170 C, then cooled under load. Free blowing gives an uneven wall and a visible thin patch at the crown.
Does the dome need a vent?
Yes, a 3 mm vent hole off centre stops condensation forming on the inside face when warm pastry is covered. Without it the dome fogs within minutes.
