Six 1:72 scale warship models arrived at a collector in the same shipment, and three acrylic model cases had stress marks at the corners before the models were even placed inside. The cases had been packed flat with the corners taking the load of the carton above.
That is a packing failure, but it points at the design decision that matters most in an acrylic model case: whether the corners are turned and bonded, and how the case is supported in transit.
Corners, base and the acrylic model case build
- Small models: 5 mm walls, bonded corners, 8 mm base
- Large models: 6 mm walls, turned corners, 12 mm base
- Clearance: 25 mm above the tallest point
- Base edge: 3 mm chamfer, felt pads
Turned corners remove the sharp internal stress line that a butt joint leaves. On a 6 mm case 400 mm tall, that difference decides whether the corner survives a lift by the top edge.
Dust, condensation and the acrylic model case
Dust is the visible enemy and condensation is the quiet one. A case lifted off a cold model after a warm room entry fogs on the inner face, and the fog dries into water marks that are hard to remove.
Handling rules for a finished model
Lift by the base, never by the top panel; store the case upside down on a clean cloth when the model is out; and keep a spare set of felt pads because the originals compress after a few seasons.
River People builds cases to model footprint with turned or bonded corners and base plates matched to load. Send the model dimensions to oversales@rpplexiglass.com.
Send the model footprint, height and base preference to oversales@rpplexiglass.com for a quotation on cases with turned or bonded corners.
Collectors often store books and models side by side, and the acrylic book display build sets out shelf support for heavy rows.
Frequently Asked Questions
Why did a case arrive scratched?
Usually from dust wiped with a dry cloth. Cases should be cleaned with a wet microfiber and a drop of detergent, never dry.
Should the case be vented?
Light venting at the base stops condensation on models stored in cold rooms. Sealed cases suit museums with stable climate.
Which base for a heavy model?
12 mm acrylic or 18 mm MDF faced with acrylic. A 5 mm base bows under a die cast model over about 3 kg.
