An ABS casino chip tray spends its life being dragged, dropped and stacked, and the failure everyone reports is a cracked rim at the fill end, where the floor supervisor grabs it with one hand.
That is a forming decision, not a resin one: rim geometry and wall thickness at the lift point.
Geometry and the ABS casino chip tray
- Tray: 400 x 300 mm, 2.5 mm ABS, four chip rows
- Rim: 6 mm rolled edge, 45 mm wall height
- Denomination wells: 43 mm pitch for 39 mm chips
- Base: 1.5 mm felt insert, hot melt bonded
A rolled 6 mm rim spreads the lift load across the whole front edge instead of one corner. The same tray with a flat rim cracks within a year on a busy pit, and a cracked tray is a security item because chips can escape into the table well.
Feel, colour and the ABS casino chip tray
ABS forms in matte colours and holds them without the translucency that makes acrylic look cheap on a felt table. Black, burgundy and deep green are the usual floor colours, and a 1.5 mm felt insert in a matching or contrasting tone stops chips sliding when the tray is tilted.
Cleaning and the long service life
Alcohol wipes are the daily routine and ABS takes them. Acetone based cleaners, used once by a new hire, turn the surface chalky and cannot be recovered. A wipe down with 70 percent alcohol and a dry cloth is the whole maintenance schedule for ten years of service.
River People forms trays to your denomination layout with felt inserts fitted and colour matched to the floor. Layouts go to oversales@rpplexiglass.com.
Send the chip denominations, table layout and colour requirement to oversales@rpplexiglass.com for a quotation with a formed sample.
Tooling, draft and draw ratios for formed ABS are covered in our ABS vacuum forming guide.
Frequently Asked Questions
Why ABS rather than acrylic for a chip tray?
A dealer drops the tray on the table edge several times a shift. ABS bends and recovers; acrylic cracks at the rim.
Which thickness for a 400 mm tray?
2.5 mm for a two row tray, 3 mm for four rows or any tray that is lifted out for a fill.
Can the tray be cleaned with alcohol?
Yes, ABS tolerates alcohol wipes. Acetone and strong solvents attack it and turn the surface chalky.
