A petg hydroponic tray is judged on three things that never appear in a catalogue: whether it sags between rack supports at full water load, whether it yellows under the lamp, and whether it cracks when a worker drops it at the end of a harvest.
All three come back to the forming detail and the grade, not to the resin choice alone.
Forming and the petg hydroponic tray
- Channel tray: 1.5 mm PETG, 100 mm channel width
- Wide tray: 2 mm, 300 mm span maximum unsupported
- Draft angle: 3 degrees minimum for stacking
- Corner radius: 8 mm, no sharp internal corners
A 1.5 mm tray formed with 3 degrees of draft stacks fifty high without jamming, and it releases from the tool without a vacuum assist. Drop the draft to 1 degree and the trays bind at thirty, which is where most forming shops quietly lose their margin.
Light, nutrients and the petg hydroponic tray
Standard PETG carries no UV stabiliser because most of it goes into packaging. A tray sitting under glass in a Mediterranean glasshouse sees enough UV to yellow inside one season, and a yellow tray reflects less light back to the canopy. A stabilised grade costs a few percent more per kilogram and keeps the tray clear for five years.
Cleaning between crops
Hypochlorite at 200 ppm is the standard sanitising rinse and PETG tolerates it. The failure comes from hot water: a tray rinsed at 70 C relaxes the formed geometry and the channel no longer drains evenly, which shows up as root rot in one bay.
River People forms trays to your channel section with tooling quoted once, and supplies food contact grade certificates. Sections go to oversales@rpplexiglass.com.
Send the channel section, tray footprint and rack layout to oversales@rpplexiglass.com for a quotation on formed trays with tooling cost split.
Food contact compliance for the same resin is set out in our PETG food tray guide.
Frequently Asked Questions
Will PETG hold up under grow lights?
Indoors yes. Under glasshouse daylight a standard grade yellows within a season, so a UV stabilised PETG is specified where the tray sees direct sun.
Which thickness for an NFT channel?
1.5 mm for channels up to 100 mm wide, 2 mm where the tray spans more than 300 mm unsupported.
Is the material food contact approved?
PETG is available in grades compliant with EU 10/2011 and FDA food contact notification. Ask for the grade certificate with the order.
