A portable meter is only as good as the shell around it, and an ABS instrument case is specified by the drop it must survive and the seals it must keep rather than by the wall thickness on a catalogue sheet.
An instrumentation maker in Pune shipped 600 handheld meters in a 2 mm shell with a plain gasket. Field returns showed water ingress at the latch land after monsoon use, and the fix was a 3 mm shell and a gasket groove rather than a new latch.
Drawing an ABS instrument case
- Depth: up to 300 mm with 15 mm draw radii
- Wall: 2 mm light, 3 mm heavy
- Ribs: 8 mm pitch on the lid face
- Gasket: seated in a groove, not on a flat land
The draw radius sets the usable depth, and a shell drawn too deep thins at the corners exactly where a drop lands. Ribs on the lid face keep the surface from drumming and add stiffness where the case is carried.
Seal, latch and hinge
A gasket pressed onto a flat land leaks at the corners when the shell flexes. A groove that holds the gasket in place keeps the seal line where it was designed, and the latch pulls the two halves against the groove rather than against a flat face.
Hinge life
A moulded living hinge on ABS is convenient and fails after a few hundred cycles in cold weather. A pin hinge with a metal insert outlasts the instrument, which is the standard a service case should meet.
Forming practice for shells of this type is covered in ABS vacuum forming.
Send the instrument envelope, protection target and order quantity to oversales@rpplexiglass.com for a case quotation.
Frequently Asked Questions
Which thickness for an ABS instrument case?
2 mm for a light meter, 3 mm for anything above 3 kg or stacked in a store. A thicker shell holds the latch land flat and resists a drop better.
Can ABS be thermoformed into a case?
Yes, and it is the usual process for a portable shell. ABS draws well to 300 mm depth with ribs, and it holds a textured surface for grip and appearance.
