A tool box on site is sat on, kicked and loaded past its rating, and an ABS tool box survives that through corner geometry and rib layout rather than through a heavier wall across the whole shell.
A mechanical contractor in Doha bought 200 totes for site crews. The first batch split at the lower corners within months, all where a sharp radius had thinned the wall during forming.
Corner and rib rules for an ABS tool box
- Wall: 3 mm tote, 4 mm stacked box
- Draw radius: 15 mm minimum at the base corners
- Ribs: 10 mm pitch, 4 mm depth
- Corner boss: 8 mm thick at each foot
The split starts where the sheet stretched to a sharp radius and lost half its thickness. A 15 mm radius keeps material at the corner, and a local boss at each foot takes the drop.
Tray, divider and latch for gloved hands
Dividers and an inner tray are handled with gloves, so a latch that needs a fingernail is the wrong latch. A wide paddle latch with a positive click works with a glove and can be checked by feel, and it also survives being closed with a boot.
Where the load actually goes
A loaded box lifts from the handle, and the handle pulls the side walls inward. A handle moulded into the side wall with a reinforcing rib under it keeps the box from bowing, and the lid then still closes.
Cutting and finishing for prototypes uses the same rules as ABS sheet cut to size.
Send your tote dimensions, load target and quantity to oversales@rpplexiglass.com for a quotation.
Frequently Asked Questions
Which thickness for a site tool box?
3 mm for a tote under 10 kg, 4 mm for a box that is dropped and stacked. Corner radius and ribs matter as much as the wall.
Why do tool boxes split at the corners?
Thin walls at a sharp draw radius. A 15 mm radius keeps wall thickness at the corner, and a corner boss spreads a drop load instead of concentrating it.
