ABS Printer Housing: Enclosure Build

The material decision for an abs printer housing is usually made on cost and then defended on temperature. Both arguments are legitimate, and they point to different answers depending on where the chamber sits in the build.

A comparison, then the details that decide a build.

ABS, PC and PC/ABS for the abs printer housing

  • ABS: 2.5 mm, chamber under 60 C, lowest cost per panel
  • PC/ABS: 2.5 mm, chamber 60 to 80 C, better creep and impact
  • PC: 2.0 mm, chamber above 80 C, needs a harder tool and slower cycle
  • All three: ribs at 150 mm centres, 1 degree draft, 0.5 mm radii
ABS printer housing enclosing a desktop 3D printer

ABS is the cheapest of the three per kilogram and the easiest to form, which is why it dominates desktop enclosures. Its weakness is creep: a flat panel held at 60 C for a year loses flatness, and a housing that has crept stops sealing at the door.

Door hinge and the abs printer housing gasket line

The hinge takes the door weight and the gasket takes the seal load, and both land on the same face. A hinge boss bonded or screwed into a 2.5 mm wall concentrates load on a small area; a metal hinge plate spanning 80 mm spreads it. The gasket should sit in a 4 mm rebate so the door closes onto rubber rather than onto a machined edge.

Window, filtration and the abs printer housing build

A clear window is the part that fails first, because it sees the heat and the solvent. An acrylic window crazes at the screw holes near a heated bed; a polycarbonate window tolerates it. Where the housing includes a filter port, the port should be formed rather than cut, so the wall section stays continuous around the opening.

River People supplies housing panels and formed covers in ABS, PC/ABS and PC to your envelope, with hinge plates and gasket rebates. Send the chamber temperature and volume to oversales@rpplexiglass.com.

Send the printer envelope, chamber temperature and annual volume to oversales@rpplexiglass.com for a quotation on housing panels and formed covers.

Enclosures built around a heated bed rather than a gantry are covered in polycarbonate 3D printer enclosures.

Frequently Asked Questions

ABS or PC/ABS for a printer housing?

ABS where the chamber stays under 60 C and cost matters. PC/ABS where the housing also carries a gantry load or sits near a heated bed above 70 C.

What wall section resists creep?

2.5 mm with ribs at 150 mm centres. A flat 2 mm panel at 60 C creeps visibly over a year of continuous running.

How is the window joint sealed?

A 3 mm EPDM gasket in a 4 mm rebate, so the acrylic or polycarbonate window sits on the gasket rather than on the housing edge.