PETG Seedling Tray: Nursery Reuse Cycle

A grower in the Netherlands replaced a petg seedling tray stock twice in two seasons before changing the specification. The trays had been 0.8 mm unstabilised PETG, bought at the lowest unit price, and by the second summer 30 percent had split at the cell rim.

The replacement was the same polymer at 1.2 mm with UV stabilisation. Unit price rose about 20 percent and the stock ran five seasons.

Wall, draft and the petg seedling tray cell

  • Wall: 0.8 mm for a single season, 1.2 mm for a reuse target above three seasons
  • Cell draft: 4 degrees per side, 40 mm cell
  • Rim: 2 mm radius, no sharp lip
  • UV: stabilised grade for any tray that sits outdoors
petg seedling tray holding young plants in a nursery

Root binding is a draft problem, not a material one. At 3 degrees a tomato plug with a fibrous root tears on release and the grower loses the transplant; at 4 degrees the plug slides out with a light pull. That single degree is worth more than any coating.

Sunlight and the petg seedling tray ageing

UV exposure is what ends a tray life, and it acts on the rim first because the rim is thin and takes the load. A stabilised grade holds its impact through five summers on a bench in partial shade. A tray that sits in full sun on a south facing bench needs the thicker wall regardless of the stabiliser.

Hygiene and the petg seedling tray between cycles

Trays are washed between cycles, and hot water above 60 C distorts a 0.8 mm cell. A 1.2 mm wall takes a 55 C wash without movement, which is another reason a reuse specification starts at that thickness.

River People supplies trays to your cell pattern with draft, radii and stabilised grades matched to the reuse target. Send cell count and seasons to oversales@rpplexiglass.com.

Send the cell count, cell volume and reuse target to oversales@rpplexiglass.com for a quotation with one tray for a season trial.

Growing systems that hold water rather than plugs are covered in PETG hydroponic tray channels.

Frequently Asked Questions

Why PETG rather than PVC for a tray?

Root release and recyclability. A PETG cell with 4 degrees of draft releases a root plug cleanly, and the tray can go into a PET recycling stream.

How many seasons does a tray last?

1.2 mm stabilised trays commonly run five seasons under a nursery bench. Thin unstabilised trays crack at the cell rim in the second summer.

What draft stops root binding?

4 degrees per side on a 40 mm cell. Below 3 degrees a fibrous root grips the wall and the plug tears on release.