The acrylic monitor stand is one of the few desk accessories where the buyer judges the part by feel rather than by a drawing. If the top flexes when the screen is nudged, the product reads as cheap regardless of how clean the edge is.
We quote these on a deflection number rather than a thickness. A buyer who asks for 12 mm without knowing the load often comes back for 15 mm after the first sample, and the difference in freight is smaller than the cost of a second tooling round.
Load and deflection on an acrylic monitor stand
- Plate: 12 mm cast acrylic, 600 x 220 mm
- Legs: four, 40 mm tall, 25 mm diameter, inset 40 mm
- Load case: 12 kg screen plus a 2 kg arm at the rear edge
- Target mid span deflection: under 0.8 mm
A flat plate on four corner supports behaves as a simply supported panel. Deflection scales with the cube of span, so a 700 mm stand at the same thickness is nearly twice as flexible as a 600 mm one. Buyers who plan a dual screen riser should expect 15 mm.
Cutting, joining and polishing
Top and legs are cut from the same cast sheet so the colour matches. A riser assembled from two production lots can show a faint tint difference where the light passes through the joint, and that difference is what customers notice in a photograph.
Legs are joined with a two part adhesive on a machined spigot, not bonded flat. A spigot carries the load in shear and keeps the leg concentric, so the stand does not lean after a year of use.
Finishing for office light
Diamond polished edges and a flame polished top face give the clearest result, but a fully polished top shows fingerprints under downlight. Many buyers choose a satin top face and polished edges, which hides touch marks and still reads as glass clear from a metre away.
River People cuts monitor stands to your screen width and quotes a deflection figure at the load you give. Send the dimensions to oversales@rpplexiglass.com and we will return a drawing for approval before production.
Send your screen width, load and desk depth to oversales@rpplexiglass.com for a quotation with a deflection figure at your load.
Desk parts raise the same deflection questions as furniture tops, and the acrylic sheet for furniture covers span against thickness in more detail.
Frequently Asked Questions
What thickness for a monitor stand carrying 12 kg?
12 mm cast acrylic on four legs, with the legs inset 40 mm from the edges. A 10 mm top sags about 1.5 mm at mid span on a 600 mm width, which is visible as a shadow line under the screen.
Why four legs instead of two side panels?
Side panels look cleaner but block the space where a keyboard sits. Four 40 mm legs leave the desk usable and spread the load to the corners, which is where a flat plate is stiffest.
How should cables be routed?
A 25 mm slot at the rear centre, cut before polishing. Cables passed over the back edge pull the stand forward every time the desk is cleaned.
