Acrylic bookends solve a display problem that metal cannot: they hold a row of books and leave the shelf looking as if nothing is there. The trade is that the part must be thick enough to resist the row and clear enough to disappear.
A reference library in Leeds replaced its steel bookends after a reader complained that the metal ends hid the spine of the last book in each row. The acrylic replacement was 8 mm, 150 mm tall and 130 mm deep, and the complaint disappeared.
Load path in an acrylic bookends pair
A bookend does not carry vertical load, it resists the horizontal push of a leaning row. That push acts near the top of the vertical leg and is carried by the bend, the base and friction with the shelf. The bend is therefore the critical section, not the flat plate.
- Vertical leg: 150 mm tall for a standard 300 mm shelf gap
- Base: 130 mm deep, which is the book depth plus 20 mm
- Bend: 90 degrees with a 3 mm inside radius
- Pad: 0.5 mm EVA under the base
Base depth is set by book depth rather than by looks. A 130 mm base under a 110 mm book leaves 20 mm of lever arm behind the centre of gravity, which is what keeps the pair from tipping when a reader pulls a book out sideways.
Bending, annealing and edge finish
The strip is heated along a line with a resistance element, bent against a former and held until it cools. Cast acrylic tolerates this because it has low internal stress; extruded sheet of the same thickness crazes at the outside radius about one time in three.
Edges are diamond polished rather than flame polished on this part, because flame work near a bend relaxes the material and the corner loses its square. Diamond polishing leaves a slightly matte edge that reads as clean but does not draw the eye.
Shelf load check
Libraries should add the weight of the row to the shelf rating rather than assume bookends carry it. A 300 mm run of hardbacks weighs roughly 12 to 15 kg, and the pair of bookends only resists the lean, it does not support the shelf.
River People cuts, bends and pads bookends in Anqing to the shelf dimensions you send, and packs them flat in pairs so the bends arrive square. Email oversales@rpplexiglass.com with shelf height, book depth and quantity.
Send your shelf height, book depth and quantity to oversales@rpplexiglass.com for a quotation on cut and bent bookends.
Shelves that already carry a display unit often need the load shared, and the acrylic book display build shows how shelf support is arranged for heavy rows.
Frequently Asked Questions
What thickness should acrylic bookends be?
6 mm for a shelf row up to 300 mm of books, 8 mm above that. A thin bookend flexes under a leaning row and slowly walks along the shelf.
How is the bend made without cracking?
Cast acrylic is strip heated along a line and bent at a 3 mm inside radius. Bending cold or with too tight a radius crazes the outside of the corner, which is where these parts always fail.
Will the bookend scratch a wooden shelf?
A 0.5 mm felt or EVA pad under the base stops it. Clear acrylic on lacquered wood shows fine scratches after a season of reshelving.
