A colour bar in a busy salon is a chemical bench as much as a display, and an acrylic salon station is specified by what it survives rather than by how it photographs on the day it is installed.
Three chairs in a salon in Brisbane were fitted with 6 mm colour bars. Nine months later the drawer fronts had clouded along the bottom edge where peroxide drips collected, and two units showed fine crazing near the drawer rails.
Chemical reality behind an acrylic salon station
- Peroxide at salon strength: short contact is fine
- Acetone and solvent remover: wipe immediately
- Colour pigment pastes: check the carrier solvent
- Bleach based cleaner: avoid on bonded seams
The failure is rarely a single dramatic spill. It is a drip line at the drawer front, wiped late, that dulls the edge and then crazes under the flex of a loaded drawer.
Drawer and shelf detailing
A drawer body needs stiffness over its depth. At 400 mm depth, 6 mm with a chamfered entry and a rail that runs the full length slides cleanly; a 4 mm body pulled slightly off axis binds, and staff then pull harder, which is where the crazing starts.
Colour pots and dividers
Dividers sized to the actual pot range stop the drawer from becoming a loose box. A 4 mm divider on 90 mm centres holds 60 mm pots upright and lets a stylist read the shade without lifting the pot out.
What the finish has to tolerate
An edge polish that survives daily wiping is a polished, flame treated or diamond finished edge rather than a sanded one, because a sanded edge holds chemistry and looks chalky after a month.
The same applied to a home vanity is set out in acrylic makeup organizer design.
Send your station layout, colour count and order volume to oversales@rpplexiglass.com for a quotation.
Frequently Asked Questions
Does acetone attack acrylic?
Yes. Acetone and chlorinated solvents stress cast acrylic and can craze it under load. Peroxide at salon strength is not a problem for short contact, but a solvent spill should be wiped immediately rather than left.
Why do colour bar drawers jam?
Sagging rails and square edges. A drawer body in 6 mm with a 2 mm chamfer at the entry slides cleanly; a 4 mm body over a 400 mm depth flexes and binds as it is pulled off axis.
Is acrylic heavy enough for a work station?
A well bonded 8 mm unit carries a normal colour bar load without trouble. The limit is point loading, so a hot iron rest or a heavy pump set needs a local support rather than a thicker panel everywhere.
