An acrylic sunglass display is a handling device first: every frame is lifted, opened, tried and replaced, and the stand has to return each frame to the same position without a staff member adjusting it.
An optical chain in the Netherlands tested three stand designs in one store over a month. The version with slotted rests needed resetting every evening; the peg version stayed aligned for the full month with no reset.
Rest geometry on an acrylic sunglass display
- Peg spacing: frame bridge width plus 3 mm
- Backward lean: 8 to 10 degrees
- Peg height: 12 mm, rounded top
- Tier pitch: frame height plus 25 mm
Frame creep is the quiet problem. A frame that rotates a few degrees each time it is replaced ends up facing the wall by mid afternoon, and the customer sees a disordered display without being able to say why.
Optical surfaces and polishing
Anything within 100 mm of a lens is flame polished or diamond finished and left without a sharp edge. A sawn edge touching a lens leaves a scuff that reads as a scratched product, and the customer blames the frame.
Tier pitch against frame height
A 150 mm frame on a flat stand hides the frame behind it. A tier pitch of frame height plus 25 mm lets a customer see the top bar of every frame from standing height, and that is the detail that sells more than an extra tier.
Restyling and durability
Stands that are lifted and moved need a base plate thicker than the rest of the unit, and no bonded joint where a hand grips. Where a stand must be carried, a 6 mm base with radiused corners survives a floor drop that cracks a square corner.
Mounting and shelf proportions are covered in tiered acrylic display rack design.
Send your frame count, counter depth and store rollout plan to oversales@rpplexiglass.com for a display quote.
Frequently Asked Questions
Which thickness for a sunglass stand?
4 mm for a single frame rest, 6 mm for a tiered stand carrying five or more frames per tier. A stand lifted by staff at restyling needs 8 mm at the base.
How do frames stay upright without a slot?
Two nose bridge pegs spaced to the frame bridge width, plus a slight backward lean. Slots wear and chip; pegs hold the frame by the bridge and let a customer lift it cleanly.
Will a clear stand scratch lenses?
Not if every surface within 100 mm of a lens is flame polished and the pegs are rounded. A sawn edge in contact with a lens is what leaves a mark.
