Acrylic Spice Rack: Kitchen Drawer Fit

An acrylic spice rack is a drawer insert that holds jars upright while a cook pulls the drawer in and out with wet hands, and the design brief is stiffness, jar spacing and a base that wipes clean rather than a decorative shape.

A condiment brand in Dubai asked for 200 drawer trays for a private-label kitchen range. The first sample held 12 jars at 60 mm spacing, but the drawer measured 452 mm inside against 460 mm on the drawing, and every tray had to be re-cut 8 mm narrower.

Sizing an acrylic spice rack to a real drawer

  • Measure the drawer interior, not the cabinet front
  • Jar diameter plus 4 mm clearance between stops
  • Base 5 to 6 mm, dividers 3 to 4 mm
  • Leave 15 mm at the back for the drawer runner

Jar spacing is calculated from the largest jar in the set, not the average. A 63 mm grinder and a 45 mm pepper jar in the same tray will rattle if the stops follow one nominal diameter, and customers read rattle as poor quality.

Steam, oil and the cleaning routine

acrylic spice rack jar tray fitted inside a kitchen drawer

The two agents that damage a kitchen tray are hot oil and alkaline degreaser. Oil leaves a film that traps dust; a strong degreaser left on the surface for minutes dulls the edge polish and can craze a stressed corner. A neutral detergent and a soft cloth handle both.

Where the tray meets the counter edge, the finish that survives wiping is described in acrylic edge finishing; blank sizes and cut tolerances are covered in acrylic cut to size.

Send your jar count, drawer interior size and target quantity to oversales@rpplexiglass.com for a rack quotation.

Frequently Asked Questions

Which thickness suits an acrylic spice rack?

3 to 4 mm for dividers and jar stops, 5 to 6 mm for the outer frame and any section that is lifted out of the drawer. Thicker stock also holds a routed divider groove without splitting.

Will acrylic crack around the feet?

Only if the feet are drilled and bolted without clearance. A tray sits on its base, so the usual failure is a screw hole drilled tight into 4 mm sheet during a retrofit. Clamp-fit feet avoid the issue.

Can the rack go in a dishwasher?

No. The wash is fine, the dry cycle is not: sustained heat above roughly 70 C relaxes the sheet and the tray bows. Hand wash with a neutral detergent keeps the edges clear.