Acrylic Stove Splashback: Heat Limits

An acrylic stove splashback is the one kitchen product where the honest answer is sometimes no. Cast PMMA deflects near 95 C; the air above a gas burner passes that within 200 mm of the flame.

That single number decides the specification, and it is the number most online listings leave out.

Thermal envelope of the acrylic stove splashback

  • Continuous service: 70 C to 80 C
  • Deflection point: 95 C at 1.8 MPa
  • Gas hob clearance: 150 mm minimum, with infill
  • Induction clearance: 100 mm, panel not in the plume

Behind an induction hob the panel sees radiant heat from pan bases and steam, not flame. Measured at 100 mm above the worktop, a busy induction kitchen stays below 60 C, which is inside the envelope. Behind gas, temperatures at the same height pass 110 C when a large burner runs, and no thickness of acrylic changes that.

acrylic stove splashback panel behind an induction hob

The compliant detail is a 150 mm non combustible strip between hob and panel, with the acrylic starting above it. Kitchens that cannot give up that strip should use toughened glass, and saying so costs a sale but keeps the panel out of a warranty claim six months later.

Fixing, expansion and the acrylic stove splashback

Acrylic expands roughly 3 mm per metre across a 50 K swing. A panel bolted tight to a wall with no clearance buckles between fixings, and the buckle line collects grease that no cloth reaches. Fixing holes at 2 mm oversize, with a continuous adhesive bead carrying the load, keeps the panel flat.

Cleaning agents that end a splashback early

Alcohol based degreasers craze cast acrylic within a season, and the crazing looks like a scratch pattern under kitchen downlights. Neutral detergent and water, wiped dry, is the whole maintenance schedule.

River People reviews splashback drawings against your hob type before quoting, and supplies 4 mm or 6 mm panels cut to the opening. Send the layout to oversales@rpplexiglass.com.

Send your hob type, splashback height and fixing detail to oversales@rpplexiglass.com for a technical review before any order is placed.

The thermal numbers behind these clearance rules are explained in our note on acrylic bending temperature.

Frequently Asked Questions

Is acrylic allowed behind a gas hob?

Not directly. Radiant heat and flame spill exceed the service temperature of cast PMMA. A minimum 150 mm clear gap with a non combustible infill is required, and most kitchens cannot provide it.

What about induction?

Induction is workable because the panel itself is not heated, but steam and radiant heat from pans still apply. 6 mm with a 100 mm clearance is the practical minimum.

How should the panel be fixed?

On a continuous adhesive bead with 2 mm clearance in the fixing holes. Point loads from screws are where crazing begins.