Polycarbonate Photo Booth Enclosure

Event hardware is treated like furniture, and a polycarbonate photo booth enclosure is a clear box that has to survive being loaded into a van and leaned on by a queue of guests.

A booth hire company in Birmingham ran four units through a wedding season. Three panels cracked at the base corners, all where a clamped edge had been tightened onto a square corner detail.

Frame stiffness in a travelling polycarbonate photo booth enclosure

Panel and corner

  • Panel: 5 mm clear, 8 mm at the base
  • Corner: 8 mm radius, clamp strip follows it
  • Base rail: continuous, no point fixings
  • Weight: keeps the box stable in a queue

A clamped edge on a square corner concentrates load exactly where a guest leans, and that is where the crack starts. A radiused corner with a continuous rail spreads the same load along the panel.

Optical cleanliness in front of the lens

The camera looks through one panel, and that panel is the one to keep clean and unmarked. A 5 mm clear face, cleaned with a microfibre cloth and replaced when scratched, keeps the output sharp without a photographic filter.

Lighting and reflection

polycarbonate photo booth enclosure with a camera inside at an event

A flash facing the panel returns a bright patch into the image. Placing the light behind the lens axis and keeping the interior dark removes the reflection, and it is cheaper than any optical coating on the panel.

Cut panels for booth builds are covered in polycarbonate cut to size.

Send your booth dimensions, transport method and event schedule to oversales@rpplexiglass.com for a quotation.

Frequently Asked Questions

Which material in front of the camera?

Polycarbonate, 5 mm, in a frame that does not preload the panel. Impact from guests is the risk, and a clear optical face keeps the image clean.

How are reflections controlled?

Lighting outside the panel and a dark interior behind the camera. A lamp facing the panel puts a bright patch in the image, so the flash sits behind the lens axis.

Can a booth panel be replaced on site?

Yes, if the frame uses removable clamp strips. A booth that travels weekly needs a panel swap in minutes, since a broken panel otherwise takes the booth out of a booking.