Polycarbonate Robot Vacuum Shell: Tooling to PPAP

The path from a polycarbonate robot vacuum shell model to a shipped unit runs in four stages, and the schedule usually slips in the second one. Here is the sequence with the decisions that gate each stage.

Stage one, material and section. Stage two, tooling. Stage three, first article and drop. Stage four, cosmetic standard and run.

Material and section of the polycarbonate robot vacuum shell

  • Top cover: 1.8 to 2.2 mm polycarbonate, 1 degree draft, 0.5 mm radius on all edges
  • Screw boss: 2.5 mm wall, 4 mm boss diameter, 8 mm deep
  • Base pan: 2.0 mm polycarbonate or PC/ABS where paint is used
  • Air gap over battery: 1.5 mm minimum, ribbed inner surface
polycarbonate robot vacuum shell on a floor cleaning robot

A 1.8 mm cover is the point where drop performance and weight cross. Thinner sections pass a 1 m drop onto tile but a 2 kg unit landing on a corner will split at the boss, and a split boss is a field failure rather than a cosmetic reject.

Tooling and the polycarbonate robot vacuum shell gate position

Gate position decides where the weld line sits on a visible face. On a top cover the gate should land on the underside or under a bumper, never on the crown, because a polycarbonate weld line reads as a faint matte streak under a shop light and cannot be polished out.

Drop, cosmetic and the polycarbonate robot vacuum shell release

First article is dropped from 1 m onto tile at three orientations, then inspected for cracks at bosses and for latch retention. The cosmetic standard follows: a scratch of 0.2 mm on the crown is a reject, a scratch of the same size on the underside is not. Writing that standard down before the run prevents two weeks of debate at shipment.

River People reviews closure models for draft and section, builds first articles and runs production shells with drop records per lot. Send the model and volume to oversales@rpplexiglass.com.

Send the closure model, drop specification and annual volume to oversales@rpplexiglass.com for a quotation on tooling review and first article.

Fixed guarding around the same kind of machine is covered in polycarbonate robot cell guard panels.

Frequently Asked Questions

Why polycarbonate rather than ABS for a top shell?

Drop performance at a thin wall. A 1.8 mm polycarbonate top shell survives a 1 m drop onto tile where an ABS shell of the same section splits at a screw boss.

What wall section is typical?

1.8 to 2.2 mm on a top cover, 2.5 mm at a screw boss, with 1 degree draft minimum.

How is creep handled over a battery?

A ribbed inner structure and a 1.5 mm air gap over the cell, so the shell does not sit at cell temperature for its service life.