A service call for a cracked petg refrigerator crisper drawer almost always describes the same part: the runner tab at the front, split along the pull direction. The wall itself is intact. The drawer was not overloaded and the cabinet was not faulty.
Three details in the formed part decide whether that happens.
Radius and the petg refrigerator crisper drawer runner
- Wall: 1.5 mm for a standard drawer, 2.0 mm for a deep bin
- Runner: 2 mm internal radius minimum, 3 mm preferred
- Rib: 0.8 mm depth under the runner, full width
- Clearance in the cabinet: 2 mm per side for cold contraction
A sharp internal corner in a thermoplastic is a stress raiser by definition. On a drawer pulled twice a day for ten years, that corner takes roughly 7,000 load cycles, and a 1 mm radius at 4 C is enough to start a crack that then runs the length of the runner.
Cold performance and the petg refrigerator crisper drawer
PETG holds its impact at refrigerator temperature where acrylic becomes brittle. That is the whole reason a drawer is PETG and not acrylic, and it holds down to about minus 10 C. A drawer that also sees a freezer compartment needs a different material entirely, because the impact advantage is gone by then.
Cleaning and the petg refrigerator crisper drawer clarity
A formed PETG drawer is clear enough to read the produce through it. Concentrated citrus cleaner and water above 60 C stress crack the runner and haze the wall, and both are common in domestic kitchens. A neutral detergent at hand warm temperature keeps the part clear for its service life.
River People forms drawers to your envelope with radiused runners and cabinet clearance built in. Send the drawer geometry and cabinet temperature to oversales@rpplexiglass.com.
Send the drawer envelope, runner geometry and cabinet temperature to oversales@rpplexiglass.com for a quotation on trial drawers.
The liner behind a drawer is a different material with its own rules, set out in ABS refrigerator liner panels.
Frequently Asked Questions
Why does a drawer crack at the runner?
Because the runner is a sharp internal corner loaded every time the drawer is pulled. A 2 mm internal radius removes the stress concentration.
Does PETG stay tough in a fridge?
It keeps usable impact at 4 C, which is why it is chosen over acrylic for a drawer that gets knocked. Below minus 10 C it loses that advantage.
What cleaning chemical damages a drawer?
Concentrated citrus degreasers and hot water above 60 C. Both stress crack a formed drawer at the runner within a few wash cycles.
