At speed, spray arrives as pressure rather than drops, and a polycarbonate speed boat windshield is held by a seal line that has to tolerate a hull flexing under every wave.
A builder in Auckland fitted a 8 mm screen to a 7 m sport boat with a bead of marine sealant along the lower edge. The first rough passage opened the bead at the middle and water ran onto the dash for the rest of the season.
Polycarbonate speed boat windshield: seal along the spray rail
- Gasket: 3 mm EPDM, continuous
- Clamp strip: full length, 20 mm cover
- Fixings: 120 mm centres
- Sealant: none relied on for the primary seal
A gasket under a clamp strip tolerates movement, while a bead alone cracks where the hull flexes. Centres at 120 mm hold the gasket in compression along the whole length, which is what stops water tracking in from the rail.
Curvature and the frame
A flat screen in a curved frame is pulled into shape by the fixings, and the panel then carries preload before it ever meets spray. Either form the panel to the hull profile or design a frame that presents a flat land, and never rely on the bolts to bend a screen.
Wipers and cleaning at speed
A wiper on a polycarbonate screen needs a wet cycle and a clean blade, or the dry pass grinds salt into the surface. Rinsing after every passage and a scratch resistant outer face keep a screen readable through a season.
Scratch behaviour under a wiper is covered in polycarbonate scratch resistance.
Send your hull profile, screen drawing and service speed to oversales@rpplexiglass.com for a quotation.
Frequently Asked Questions
Which thickness at planing speed?
6 mm for a screen under 700 mm height, 8 mm above that or where a wiper is fitted. Pressed spray loads a large panel, and a wiper adds local force.
How is the lower edge sealed?
A continuous gasket under a clamp strip, not sealant alone. Spray rail pressure finds any gap in a bead, while a compressed gasket tolerates the hull flex that opens a bead.
Can a curved section be supplied?
Yes, formed to the hull profile or supplied as a flat panel for a frame that carries the curve. A compound curve needs a mould, so the drawing should state the radius.
