Polycarbonate Jet Ski Windshield: Spray

A personal watercraft screen is bolted to a deck that moves under the rider, so a polycarbonate jet ski windshield is a fatigue component as much as a spray shield.

A rental operator in Malta replaced screens on 14 craft after one season. Every failure was a crack running from a bolt hole toward the top edge, and every craft had a flat bracket bolted to a curved deck.

Bracket and bolt detail for a polycarbonate jet ski windshield

Follow the deck

  • Bracket: matched to the deck radius
  • Hole: 1.5 mm over the bolt
  • Washer: rubber backed, both sides
  • Hardware: stainless, isolated from the panel

A bracket that does not follow the deck curves pulls the panel into shape as the bolts are tightened, and that preload is what cracks the hole. A rubber washer on both sides removes the hard contact and lets the panel float a fraction.

Spray height and rider position

A screen set 60 to 80 mm above the bars lifts spray away from a seated rider without putting the top edge in the line of sight when standing. Higher screens look protective and catch wind at speed, which loads the bracket.

Salt, sun and the edge

polycarbonate jet ski windshield mounted above the handlebars

Salt water does not attack polycarbonate, but it attacks the joint. Rinsing after use and stainless hardware keep the bracket intact, and a polished edge removes the notch where a crack would start after a season of flexing.

Marine screen forming is discussed in polycarbonate boat windshield work.

Send your model year, deck profile and quantity to oversales@rpplexiglass.com for a windshield quotation.

Frequently Asked Questions

Which thickness for a jet ski screen?

4 mm for a stock replacement, 6 mm for a raised screen used in open water. Hull flex and rider lean put more load on the panel than spray does.

How is the screen kept from cracking at the bolts?

Oversized holes, rubber backed washers and a bracket that follows the deck curvature. A flat bracket on a curved deck puts a point load at one bolt.

Is polycarbonate affected by salt?

The panel is not, but steel hardware is. Stainless fixings and a washer that isolates the panel from the bracket keep the joint intact through a season of salt water.