A garden room fails on heat before it fails on light, and polycarbonate sunroom glazing is specified around solar gain, span and how the sheet moves with temperature rather than around a preferred look.
A homeowner in Adelaide converted a veranda into a sunroom with 16 mm multiwall. The first summer the room reached 44 C inside, and the fix was a bronze tint and two roof vents rather than thicker glazing.
Span and section for polycarbonate sunroom glazing
- 16 mm multiwall: rafter spacing up to 1050 mm
- 10 mm multiwall: up to 800 mm
- Solid 8 mm: up to 900 mm with a supporting bar
- Expansion: 3 mm per metre at the upper end
The span figure is the one that gets pushed. A wider rafter spacing saves framing and shows up as a sagging sheet in the second summer, and the sag then traps water at the low end of the roof.
Heat, tint and ventilation
A tint reduces glare and solar gain while keeping winter light usable. Bronze and opal are the usual choices for a domestic sunroom; a clear sheet is appropriate where the roof is shaded for part of the day and heat is not the limiting factor.
Where the sheet meets the frame
Screws through oversized holes with a sealing washer, and a glazing bar that allows the sheet to slide, keep a summer roof from buckling. A sheet fixed tight at both ends has nowhere to go and lifts the bar instead.
Condensation in a multiwall roof
Multiwall flutes running down the slope drain condensation to the eave, where an anti dust tape and a vented closure let it out. Flutes running across the slope trap water, and the roof then shows a permanent dark band in the flutes.
Greenhouse installations use the same principles and are set out in UV resistant polycarbonate for greenhouse and roofing.
Send your roof plan, span and location climate to oversales@rpplexiglass.com for a glazing quotation.
Frequently Asked Questions
Multiwall or solid for a sunroom roof?
Multiwall 16 mm for insulation and weight, solid 6 to 8 mm where the roof is small and clarity matters. Multiwall cuts heat loss; solid gives a cleaner view and takes more structural care.
How much expansion allowance is needed?
Roughly 3 mm per metre of panel length for a typical temperature swing, left at the upper end of each sheet. Panels fixed rigid at both ends buckle in summer.
