Cutting a window into a finished van panel removes stiffness, and a polycarbonate camper window is a glazing and structural detail at once, so the frame carries as much of the job as the sheet.
A converter in Christchurch fitted 30 vans with cut in windows. Five developed leaks at the lower edge in the first winter, all where the seal had been run against a raw cut panel edge.
Seal detail on a polycarbonate camper window
- Seal type: butyl or EPDM bead, not silicone alone
- Panel edge: primed and painted before sealing
- Frame: clamps the seal along its full length
- Fixings: 150 mm centres around the opening
The raw cut edge of a van panel is where every leak starts. Priming and painting before the seal goes on gives the bead something to bond to, and the difference shows up in the first cold night rather than at handover.
Stiffness, drumming and the frame
A large opening in a thin panel flexes as the van moves, and a pane that is only sealed, not framed, drums at speed and works the seal loose. A frame with fixings at 150 mm centres ties the pane to the panel and takes the flex out of the seal line.
Condensation in a small cabin
Single glazing condenses when a person sleeps inside on a cold night. Ventilation and a thermal break at the frame do more than a thicker pane, and a window that is planned with the vent layout avoids the drip that wakes a camper at 3 am.
For cutting and edge treatment on replacement panels, see polycarbonate cut to size.
Send your van model, opening size and insulation plan to oversales@rpplexiglass.com for a quotation.
Frequently Asked Questions
Which thickness for a camper window?
6 mm for a panel opening under 700 mm wide, 8 mm above that or where the pane is walked past. A thin pane in a large opening drums and flexes the seal.
How is the window sealed?
A butyl or EPDM bead against a painted, primed panel, with a frame that clamps the seal rather than pressing it. Sealant alone on a cut panel edge fails at the first thermal cycle.
Does a camper window condensate?
A single pane will. Condensation inside a small cabin is reduced by ventilation, not by thickness, so the window is part of a ventilation plan rather than a cure for it.
