ABS Appliance Housing: White Goods Case

ABS appliance housing shells are vacuum formed from a sheet that has to hold a texture through a deep draw, and the texture is what makes a mid priced appliance look finished.

A Chinese OEM moved a washing machine top cover from 2.5 mm polystyrene to 2.5 mm ABS after returns for cracked corners at the transit bolts. The ABS version passed the same drop test with a thinner wall.

Draw depth and ribbing in an ABS appliance housing

Deep draws need a wall that thins predictably

  • Thickness: 2 mm small housing, 3 mm large case
  • Draw ratio: up to 1 to 1.2 in ABS
  • Rib pitch: 80 mm across a large face
  • Texture: matt, 0.3 mm grain

A matt grain hides handling marks and gives a large flat face some visual depth, while a gloss face on a 3 mm draw shows every thin patch as a ripple. Ribbing carries the load that the deep draw has thinned.

Colour, texture and the appliance range

ABS appliance housing formed for a domestic appliance

A colour matched across a fridge, a washer and a dryer comes from one masterbatch and one forming line. Buying the same nominal colour from two suppliers is how a kitchen ends up with two whites.

Cleaning agents in a kitchen

Appliance faces are wiped with degreasers and bleach solutions. ABS holds up better than most commodity sheets, and a textured face hides the fine scratches that wiping leaves.

Enclosure forming practice is covered in ABS equipment enclosures.

Send your part drawing, annual volume and colour target to oversales@rpplexiglass.com for a quotation.

Frequently Asked Questions

Which thickness for an appliance housing?

2 mm for a small housing with ribs and 3 mm for a large case or a structural part that carries a compressor or a drum.

Why ABS rather than polystyrene?

ABS takes impact, holds a texture and resists kitchen cleaning agents far better. Polystyrene cracks at fixing points and yellows under heat.

Does the housing need a fire rating?

Mains powered appliances are specified against a flammability requirement, and the grade is chosen for it. A general purpose sheet is the wrong input for a housing with a heating element inside.