ABS Power Tool Housing: Tool Body

ABS power tool housing shells fail in the field at the same place almost every time: the screw boss next to the battery interface, where a drop puts the whole load on a thin boss instead of the shell wall.

A tool brand in Suzhou changed the boss layout on a 18 V driver after a batch of returns. The wall stayed at 3 mm, and the shells stopped splitting when a tool came off a ladder.

Ribbing and boss design in an ABS power tool housing

  • Wall: 2 mm compact, 3 mm heavy duty
  • Rib pitch: 60 mm around the motor
  • Boss wall: 2.5 mm minimum with gussets
  • Grip texture: 1 mm moulded diamond

Ribs around the motor bay stiffen the largest unsupported face, and gussets at the bosses spread the drop load into the wall. A boss without a gusset is a designed crack path.

Grip, gloves and wet hands

ABS power tool housing moulded around a cordless drill body

A moulded diamond texture holds in a gloved hand and stays effective when the tool is wet. Applied grip pads peel at the edge, which is the first thing a trade user notices.

Vibration, heat and the motor inside

A tool body has to tolerate the motor heat and the vibration of its own use without the shell fretting against the gearbox. Clearance at the mounting points and a heat resistant grade are the two specification decisions.

Vacuum forming depth and draw limits are covered in ABS vacuum forming.

Send your part drawing, motor envelope and drop test requirement to oversales@rpplexiglass.com for a quotation.

Frequently Asked Questions

Which thickness for a tool housing?

2 mm for a compact drill body with ribs and 3 mm for a large tool or an impact driver where the shell also locates the gearbox.

Does ABS hold up to site drops?

A properly ribbed ABS shell passes the standard drop sequence, and it fails at the screw bosses if the design puts load there instead of into the shell wall.

How is grip texture formed?

In the tool, not added afterwards. A moulded texture at the grip is what survives gloves, and a stick on pad is a durability problem in a wet trade.