ABS Boat Console: Marine Dashboard

A boat builder moulding ABS boat consoles in house asked for a material recommendation with a specific complaint: consoles fitted in April were showing a chalky surface by September on boats kept outdoors.

The material was standard ABS. An ABS boat console will always chalk in direct sun unless the sheet carries a UV stabiliser or a protective cap, and that choice is made at the sheet order rather than at the mould.

Grade, thickness and the ABS boat console

  • Console under 700 mm: 4 mm UV stabilised
  • Larger dash: 5 mm, capped or painted
  • Instrument recess: 15 mm depth, 5 degree draft
  • Edge: 6 mm radius, no sharp returns
ABS boat console dashboard in a small marine craft

Capped sheet gives a thin weather layer that carries the UV protection and the colour, which is why marine consoles usually use it rather than a painted standard sheet.

Instruments, wiring and the ABS boat console build

Recess depth is set by the instrument bezel, not by the gauge. Fifteen millimetres with draft suits most chartplotters and leaves room for a wiring chase behind the dash.

Finishing for saltwater duty

Salt leaves a film that hides texture and accelerates chalking at the edges. A matte texture in a light colour hides both, and it stays cooler under a midday sun than a dark gloss finish.

River People forms consoles in UV stabilised or capped ABS with recesses and wiring chases to your layout. Send the console drawing to oversales@rpplexiglass.com.

Send the console drawing, instrument layout and build volume to oversales@rpplexiglass.com for a quotation on formed consoles and tooling.

Consoles follow the same wall and rib logic as static enclosures, and the ABS sheet for equipment enclosures covers enclosure forming in more detail.

Frequently Asked Questions

Does ABS last in salt water?

Standard ABS chalks under UV in two seasons. Marine grade with a cap layer or a painted finish holds five years or more on a lake or coastal boat.

What thickness for a console?

4 mm for a console under 700 mm, 5 mm for larger dashes or where a hand rests on the top edge while helming.

Can instruments be recessed into the form?

Yes, to 15 mm depth with draft on the recess walls. Deeper recesses need a two stage tool.