Polycarbonate Neonatal Incubator Hood

A neonatal unit replaced polycarbonate neonatal incubator hoods on eleven units within two years, and the failure was identical on every unit: a crazed band across the front wall at the height where nurses rested a hand while adjusting a probe.

The crazing came from an alcohol wipe used at the same spot every shift. That is a cleaning compatibility problem, and it decides the specification of a polycarbonate neonatal incubator hood as much as the forming does.

Forming and the polycarbonate neonatal incubator hood

  • Hood wall: 6 mm formed, 8 mm at the access opening
  • Haze: under 5 percent
  • Forming temperature: 175 to 185 C, controlled cycle
  • Edge: machined flat at the seal face, no hand trim
polycarbonate neonatal incubator hood over a hospital cot

Walls formed at a controlled temperature keep their thickness at the corners. A fast form thins the front wall by a third and that is where a crazed band develops first.

Cleaning, seals and the polycarbonate neonatal incubator hood

Alcohol and quaternary ammonium wipes are compatible. Chlorinated wipes and strong alkaline agents are not, and the damage looks like a milky band before it looks like a crack.

Observation through the wall

Nurses observe colour and breathing through the hood wall rather than opening it, so clarity is a clinical requirement rather than a cosmetic one. Haze above 5 percent starts to hide skin tone changes.

River People forms hood sections to your drawing with machined seal faces and documentation for the cleaning protocol. Send the hood drawing to oversales@rpplexiglass.com.

Send the hood drawing, cleaning protocol and regulatory pathway to oversales@rpplexiglass.com for a quotation on formed hood sections and prototypes.

Hoods and access panels are cut from the same sheet stock, and the polycarbonate sheet cutting service page covers tolerance and film protection.

Frequently Asked Questions

Which cleaning agents suit polycarbonate hoods?

Alcohol and quaternary ammonium wipes are safe. Chlorinated and strong alkaline agents craze the sheet after repeated use.

Can the hood be autoclaved?

No. Polycarbonate softens near 150 C and loses dimensional stability. Hoods are wiped and disinfected, not steam sterilised.

What clarity is needed for nursing?

A clear hood wall with under 5 percent haze so an infant can be observed through the wall at a two metre distance.