Transit interiors are specified for cleaning, vandalism and fire at once, and an ABS transit seat shell is a formed part that a fleet will judge by how it looks after five years of daily washing.
A bus refurbisher in Hamburg formed 180 shells in 3 mm ABS for a city fleet. Within a year the aisle side of every shell showed a wear line where bags brushed past, and the specification moved to a harder surface finish.
Draw and ribbing for an ABS transit seat shell
Depth against wall
- Draw depth: up to 120 mm in one pull
- Ribs: 15 mm pitch behind the back rest
- Thickness: 3 mm framed, 4 mm semi structural
- Contact: foam interface to the frame
A rib pattern behind the back rest stops the shell from drumming and carries the load into the frame. Without ribs, a 3 mm shell oil cans when a passenger leans back, and the flex is what starts a squeak at the frame.
Aisle edge and bag wear
The aisle edge is hit by bags and trolleys more than the seat itself. A slightly thicker edge band and a textured finish at that edge take the abrasion, and the same edge is where a formed shell is easiest to reinforce.
Fire performance and cleaning
The ABS grade and additive package follow the vehicle approval for flame spread and smoke, and a fabricator who cannot state the grade should not be forming a transit part. Daily cleaning with a fleet detergent also rules out a finish that chalks.
Forming limits for this family of parts are covered in ABS vacuum forming.
Send your seat frame drawing, fire standard and fleet size to oversales@rpplexiglass.com for a quotation.
Frequently Asked Questions
Which thickness for a bus seat shell?
3 mm for a shell with a full frame support, 4 mm where the shell carries part of the load or is exposed at the aisle. Ribbing matters more than the nominal wall.
Why does a shell squeak?
Contact between shell and frame. A shell that touches the frame at many small points moves against it and squeaks; a shell with a designed contact line and a foam interface does not.
What fire standard applies?
It depends on the market. Bus interiors are usually specified to a flame spread and smoke standard, so the ABS grade and any additive package are chosen by the vehicle approval, not by the fabricator.
