PETG Egg Tray: Thermoformed Farm Pack

Egg packing is a stack, a truck and a shelf, and a PETG egg tray is judged by how the bottom tray in a stack of eight looks after a cold night in a distribution centre.

A producer in Brittany moved from a polystyrene tray to 0.8 mm PETG after breakages at the cold store door. The clarity helped retail, but the first run thinned at the cup corners until the forming temperature was raised by 6 C.

Cup geometry and stack height on a PETG egg tray

  • Cup: matched to the egg size band sold
  • Stack: 4 high retail, 8 high farm
  • Thickness: 0.7 mm retail, 1.0 mm farm
  • Corner: 4 mm radius to keep wall thickness

A sharp cup corner is where the wall thins and where a tray fails first under stack load. A 4 mm radius keeps the wall continuous, and it costs nothing at the mould design stage.

Forming temperature and wall thinning

PETG egg tray holding eggs on a farm packing line

Forming too cold pulls the sheet thin at the deepest point, which is the cup base. Raising the sheet temperature and controlling the vacuum rate keeps thickness even, and a formed tray should be checked at the cup base rather than at the flat between cups.

Retail print and the shelf

A tray that is printed on the flat land rather than the cups keeps the print out of the egg contact zone and stays readable when trays are stacked. A print on the cup side wears at the point where trays touch.

Food contact grade and declaration requirements are covered in PETG sheet for food contact applications.

Send your egg size, stack height and monthly volume to oversales@rpplexiglass.com for a tray quotation.

Frequently Asked Questions

Why PETG for an egg tray?

Clarity, toughness and a clean recycling route. PETG forms at a lower temperature than PVC alternatives and takes a drop without the brittle crack that polystyrene shows at a cold store door.

Which thickness for a 30 egg tray?

0.7 mm for a retail tray stacked four high, 1.0 mm for a farm tray stacked eight high. Stack height drives thickness more than the egg load does.

Does the tray need to be food contact approved?

Yes, and the grade matters. A food contact PETG grade with the correct declaration keeps a packing line compliant, and the same sheet formed for a non food use does not.