Acrylic Candle Holder: Event Table Build

Hotel banquets keep asking for the same thing: an acrylic candle holder that disappears on a white linen table so the flame reads as the only object in the frame. Clear cast acrylic does that better than glass because the edge can be polished until it vanishes.

A wedding venue in Malaga ordered 300 holders for a season and returned 40 of them in October. The complaint was not breakage but clouding along the top rim, where staff had wiped the holders with an alcohol based cleaner between events.

Designing an acrylic candle holder around the flame

Heat is the design driver. Cast acrylic holds its shape to about 70 C in continuous service and softens near 80 C. A tealight sitting in its aluminium cup transfers far less heat than an open taper candle, so the recess is built around the cup rather than the wax.

  • Solid foot: 20 mm cast block, 70 mm diameter
  • Upper column: 8 mm tube or a machined ring
  • Tealight recess: 40 mm diameter, 14 mm deep
  • Metal liner: 0.4 mm aluminium cup, press fitted
  • Total height for a banquet table: 90 to 120 mm

Machining and polishing the acrylic candle holder

clear acrylic candle holders arranged on a banquet table

The order of operations decides whether the part looks expensive. Bore the recess first, face the bottom second and polish the outer edge last, because a polished edge that is then clamped in a chuck picks up jaw marks that no amount of polishing will remove.

Flame polishing works on cast acrylic and is the reason the material suits this product. A hydrogen and oxygen flame passed along the edge at walking speed melts a surface layer about 0.2 mm deep and leaves it optically clear. Extruded sheet releases stress under the same flame and crazes into a spider pattern.

The cleaning habit that ruins holders

Alcohol, acetone and most glass cleaners attack cast acrylic and leave a haze that reads as dirt under candlelight. Venues should wipe with lukewarm water and a drop of neutral soap, then dry with a soft cloth. Print that line on the packing slip; it prevents most returns.

For flame candles rather than tealights, the holder needs a metal insert that stands 15 mm above the acrylic surface. We cut that insert from brass or anodised aluminium and press it into the bore, so the acrylic never sees direct flame.

River People machines candle holders from cast block, polishes the light facing edges and packs them in individual foam sleeves. Send your drawing or a candle dimension to oversales@rpplexiglass.com for a price and a sample.

Send your holder drawing, candle size and event quantity to oversales@rpplexiglass.com for a sample and a quotation.

The flame polish on the rim is what makes or breaks a holder, and our acrylic edge finishing notes explain how to judge an edge before a production run.

Frequently Asked Questions

Does an acrylic candle holder melt?

Cast acrylic starts to soften near 80 C. A tealight in a metal cup set into a recess is safe because the cup carries the heat; a bare flame against acrylic will mark the surface within minutes.

What size recess for a standard tealight?

Tealights measure about 38 mm across, so the recess is cut 39 to 40 mm and 14 mm deep. A deeper recess hides the aluminium cup and gives the floating look that hotels ask for.

Can the holder be machined from 20 mm block?

Yes, and that is the usual route for a solid foot. A 20 mm block is faced, the recess is bored and the outer edge is flame polished, which removes machining marks without leaving a visible seam.