A clinic asked us to copy a stainless dispenser with an acrylic glove dispenser body, because staff had stopped using the original. The reason was simple: the box went in at an angle, jammed, and the nurse pulled the whole dispenser off the wall trying to free it.
An acrylic glove dispenser fixes that by letting staff see the box level before pushing it home, which sounds trivial until you watch a queue form at a treatment room door.
Box fit and the acrylic glove dispenser opening
Standard glove boxes run 240 to 260 mm wide and 120 to 130 mm deep depending on the brand. Building to one brand locks the clinic in, so we build to the widest box in use plus clearance.
- Body: 5 mm cast acrylic, 260 x 130 x 90 mm internal
- Side clearance: 3 mm each side
- Top gap: 5 mm for the box lid flange
- Dispensing slot: 120 x 15 mm on the bottom face
The slot sits on the bottom face rather than the front. A front slot lets the glove hang against the wall where it collects dust, and staff tear the cuff reaching sideways for it.
Fixing, cleaning and the acrylic glove dispenser in a corridor
Two keyhole fixings at the back plate and a bottom lip carry the load. The lip stops the box dropping out when a glove is pulled hard, which is the failure that ends with a dispenser on the floor.
What to tell the infection control team
Cast acrylic tolerates dilute alcohol wipes and neutral detergent. Chlorine based and strong solvent disinfectants attack the surface and leave a permanent haze that staff read as poor cleaning. A written cleaning note with each delivery prevents that argument.
River People builds dispensers to your glove box dimensions, with the slot and lip placed for the way staff actually pull. Send a box dimension or a photo to oversales@rpplexiglass.com for a quotation.
Send your glove box dimensions and wall fixing preference to oversales@rpplexiglass.com for a quotation on dispensers cut to your box size.
Clinical fit outs usually order dispensers and counter screens together, and the acrylic sneeze guard specification covers the cleaning notes both products share.
Frequently Asked Questions
What clearance should the dispenser give the glove box?
2 to 3 mm on each side and 5 mm at the top. A tight fit means staff fight the box in and out, and the acrylic cracks at the corner within a season.
How wide should the dispensing slot be?
About 120 mm wide and 15 mm deep on the bottom face. A narrow slot drags on the glove cuff and tears the first glove of every box.
Can the dispenser be cleaned with hospital disinfectant?
Dilute alcohol wipes are fine if wiped dry. Strong solvent disinfectants soften cast acrylic and leave a hazy patch, so specify the cleaning agent to the supplier before ordering.
