Polycarbonate Cold Room Door: Glazing

Cold room doors are judged by what staff can see through them at seven in the morning with the room already at temperature. A polycarbonate cold room door window that fogs or cracks turns a walk-in into a door that gets propped open, and the energy bill follows.

One distribution centre we worked with had replaced acrylic door lights three times in two years. The replacement was 10 mm polycarbonate with a heated frame, and the third replacement became the last.

Material choice for a polycarbonate cold room door

Impact strength is the deciding property. Polycarbonate retains useful toughness to minus 40 C, while cast acrylic turns brittle below freezing and fails without warning under a pallet truck strike.

  • Single pane: 8 mm for doors under 900 mm width
  • Heavy traffic: 10 mm, dry glazed
  • Double unit: 6 mm plus 6 mm with a 12 mm air gap
  • Frame heating: 12 W per metre on freezer doors
polycarbonate cold room door glazing panel in a walk-in freezer

A 900 mm door light deflects about 2 mm at 10 mm thickness under a 20 mbar wind load, which is within the gasket tolerance. At 8 mm the same load doubles the deflection and the pane starts to lift off the rebate at the centre.

Fitting, gaskets and the acrylic trap

The pane goes in dry, on EPDM gaskets, with the rebate deep enough that the gasket is compressed rather than sheared. Sealed with silicone at the edges, the pane cannot expand with temperature and eventually cracks at a fixing.

The maintenance detail

Door lights are cleaned with a soft cloth and warm water. Ammonia glass cleaner and abrasive pads haze polycarbonate permanently, and a hazed window is often read as a failed seal and replaced unnecessarily.

River People cuts polycarbonate door lights to your leaf size with edges machined square and protective film left on until installation. Send the door drawing and room temperature to oversales@rpplexiglass.com.

Send the door leaf size, room temperature and frame profile to oversales@rpplexiglass.com for a quotation on cut polycarbonate door lights.

Cold rooms feed display counters, and the polycarbonate food display guard shows how the same sheet grade is detailed where condensation and cleaning both matter.

Frequently Asked Questions

Why polycarbonate rather than acrylic for a freezer door?

Polycarbonate keeps usable impact strength at minus 20 C. Acrylic becomes brittle in a cold room and a trolley strike cracks it outright.

How is condensation controlled on the door light?

A double glazed unit with a 12 mm air gap plus frame heating, or a single 10 mm pane with an anti fog coating on the warm side. Single pane without heating fogs at every opening.

What rebate depth does a 10 mm pane need?

At least 15 mm with a dry glazed gasket. A shallow rebate pulls the gasket out of line when the door slams and the seal fails at the corners first.