Acrylic Paper Tray: Desk Filing

An acrylic paper tray is one of the few office products judged a year late. Nobody notices it on arrival. They notice the front lip when the solvent joint starts to craze and every envelope catches, and they notice the base when a full tray slides across a desk while a drawer is opened.

Three choices decide whether that happens: wall thickness, joint method and the pitch between stacked trays.

Wall thickness and the acrylic paper tray footprint

  • A4: 250 x 330 x 60 mm, 3 mm walls, 4 mm base
  • A5: 180 x 250 x 55 mm, 3 mm walls, 4 mm base
  • Stack pitch: 70 mm, plus 1 mm clearance per side
  • Legal and foolscap: 240 x 360 mm, 5 mm walls
acrylic paper tray holding A4 documents on an office desk

A tray built entirely from 3 mm sheet flexes at the rim when lifted with a full load, and a flexed rim is the start of a craze line. A 4 mm base with 3 mm walls is the balance most offices settle on. Where trays are lifted daily and stacked four high, 5 mm walls make the difference.

Solvent bonding and the acrylic paper tray joint

Dichloromethane bonds in seconds and leaves a hard stress line along the joint, which is exactly where crazing begins in a warm office. Two part acrylic adhesive needs 24 hours under clamp and produces a joint that survives flexing, at roughly double the labour cost. Volume orders usually specify solvent bonding at the back and rear corners only, where the load sits.

Static, coated paper and the acrylic paper tray finish

Cast acrylic charges less than extruded sheet, but in a heated office at low humidity a stack of coated paper still clings to the base. A 4 mm base plus a 2 mm air gap under the tray breaks most of it, and it costs nothing to design in.

River People produces trays to your paper size with polished front lips, engraved labels and export cartons per desk pack. Sizes, colours and quantities go to oversales@rpplexiglass.com.

Send the paper size, stack height and monthly quantity to oversales@rpplexiglass.com for a quotation with one sample tray per size before production.

For a look at the same joint logic in a cash handling tray, see our build notes on acrylic cash trays.

Frequently Asked Questions

Do trays need fire polished edges?

The front lip does. A sawn lip collects toner dust along the cut and reads as dirty within weeks, while a polished lip wipes clean with a cloth.

What wall thickness suits a shared filing point?

5 mm walls with a 6 mm base. A shared point takes a full ream plus folders and gets lifted weekly, which is where 3 mm walls bow.

Can the tray be made in a brand colour?

Yes, in opaque or translucent cast colours. A physical chip is approved before the first batch, because screen colour drifts between suppliers.