A specification studio returned a fan deck with a single line in the covering note: chip 14 does not match the panel we received. The acrylic sample swatch display had been built correctly and the colour was two batches apart. That one chip cost the supplier the account.
Sample libraries are a trust instrument. Everything about the build should serve the moment a designer holds a chip against a wall.
Chip geometry and the acrylic sample swatch display
- Chip: 100 x 100 mm, 3 mm cast, 6 mm corner radius
- Hole: 5 mm, 12 mm from the edge, drilled before polishing
- Binding: brass post, 25 mm barrel, one post per deck
- Label: laser engraved on the reverse, 4 mm cap height
Drilling before polishing matters. A hole drilled after polishing lifts a micro chip around the bore that shows as a white ring, and a designer reads that ring as a defect in the material rather than in the sample.
Colour control across the acrylic sample swatch display
Cast colour is mixed per batch, and a two point shift on the b scale is visible when chips sit side by side even though it is invisible on a single panel. Production decks are cut from one sheet per colour, and that sheet number is written into the label file so a replacement chip can be cut from the remainder years later.
Replacement and the working deck
Studios replace four to six chips a year as ranges change. Keeping 20 percent spare chips from the same sheet in the deck box is cheaper than re-cutting a deck, and it is the difference between a library that stays accurate and one that quietly drifts.
River People cuts, drills, polishes and engraves sample decks to your chip list, with batch traceability on every label. Send the palette to oversales@rpplexiglass.com.
Send the chip size, number of chips and label content to oversales@rpplexiglass.com for a quotation on fan decks and wall mounted sample boards.
The same edge and box tolerances appear in our acrylic specimen display guide, where chips sit in a drawer instead of a deck.
Frequently Asked Questions
What chip size works in a hand held fan deck?
100 x 100 mm with a 6 mm corner radius. Smaller chips hide the texture, larger ones make the deck too heavy to hold during a client meeting.
How is the label applied?
Laser engraved on the reverse face, so the front stays optically clean. Printed labels lift at the edges after a year of handling.
How many chips should a deck carry?
Twelve to eighteen. Beyond twenty the binding post takes the load and the deck stops lying flat on a table.
