A pin collector board is bought for one of two reasons: to show a set at a convention, or to keep it intact between conventions. The requirements are close to opposite, and an acrylic pin display board that serves the second use well usually serves the first badly.
This list is built for the collector case, which is the harder brief.
Backing, depth and the acrylic pin display board
- Plate: 3 mm cast clear for a display board, 5 mm for a case lid
- Backing: 2 mm wool felt, glued with acrylic adhesive
- Depth: 12 mm internal for pins with rubber clutches
- Grid: 25 mm spacing, printed guide sheet supplied
- Hinge boss: 8 mm diameter, 3 mm wall minimum
Felt at 2 mm holds a pin back without letting the pin rotate, and it hides the holes after a set is rearranged. At 1 mm the felt tears around the third or fourth insertion, and at 4 mm the pins sit too deep for a 12 mm case.
Hinge and corner detail on the acrylic pin display board
The corner is where a case fails. A metal pin drilled straight through 3 mm acrylic concentrates load on a 3 mm ring of material, and a case carried in a bag takes a knock at that exact point. An 8 mm boss formed by a bonded block spreads the load and moves the failure away from the corner.
Presentation and the acrylic pin display board at a show
At a convention the board goes on a table under a lamp, so the clear face matters more than the case. A 3 mm clear front with polished edges reads as glass at half the weight, and the whole board can go in hand luggage where a glass case cannot.
River People cuts boards to your pin grid with felt backing, printed guides and bonded hinge bosses. Send the pin count and case size to oversales@rpplexiglass.com.
Send the pin count, pin back type and case size to oversales@rpplexiglass.com for a quotation with one sample board before a production run.
The same felt and lid clearance approach appears in acrylic specimen display cases.
Frequently Asked Questions
Felt or cork behind the pins?
Felt at 2 mm. Cork crumbles under repeated pin insertion and the dust sits against the acrylic face where it is most visible.
What lid clearance clears a pin back?
12 mm internal depth for standard enamel pins with a rubber clutch. A 10 mm case presses on the pin heads and marks the lid.
Why do collector cases crack at the corner?
Because the lid is hinged with a metal pin straight through the acrylic. A 3 mm wall needs a 8 mm boss around the hinge hole, or the case fails at the first knock.
