A hotel on the Polish coast had 260 timber stemware racks across three floors, and the housekeeping team was washing every glass before service because the slots collected dust. The replacement order went to an acrylic wine glass rack for one reason: the slots could be cleaned with the same cloth as the shelf, and the glass no longer needed a second wash.
That decision rested on three dimensions, not on the material.
Slot geometry in the acrylic wine glass rack
- Stem slot: 12 mm wide, 70 mm long, 10 mm plate
- Bowl clearance: 25 mm minimum to the shelf below
- End gap: 40 mm from the wall for a tall bowl swing
- Rack run: 1,200 mm maximum before a centre support
A 12 mm slot for a 9 mm stem leaves 1.5 mm per side. That is enough for a tired hand at midnight and not enough for a glass to swing into its neighbour. Slots cut at 10 mm grip the stem, and a gripped stem is a stem that gets pulled sideways out of the foot.
Mounting and the acrylic wine glass rack under a shelf
The rack carries load through its ends, so a 1,200 mm run needs a support at each end and one at the centre. Bolting a rack flat to a shelf underside with no air gap traps condensation against the timber, and the timber shows a dark line within a season. A 5 mm batten at each end solves both the gap and the load path.
Cleaning and the acrylic wine glass rack in service
Cast acrylic takes a warm detergent wipe and a glass polish without hazing. The advantage over timber is that a slot can be wiped through in one pass, which removes the second wash that costs a hotel a full shift per week across 260 racks.
River People cuts racks to your glass set with polished slot edges and mounting battens supplied. Send the bowl diameter and run length to oversales@rpplexiglass.com.
Send the glass bowl diameter, stem diameter and run length to oversales@rpplexiglass.com for a quotation on racks cut to your glass set.
Cellar shelving that holds bottles rather than stems is covered in acrylic wine rack shelving.
Frequently Asked Questions
What slot width stops a glass swinging?
12 mm for a 9 mm stem, which allows a glass to be lifted out without catching. Narrower slots grip and slow the bar down at peak.
How much bowl clearance is needed?
25 mm below the rack plate to the next shelf. Anything less and a tall bowl touches, and a bowl that touches transfers weight onto the stem.
Can a rack be mounted under a wooden shelf?
Yes with a 40 mm batten at each end and a 5 mm gap for air movement, which keeps condensation off the shelf face.
