Acrylic Rack Panel: AV Cabinet Face

In a comms room the rack door is opened far less often than the indicator lights change, and an acrylic rack panel is a window into a cabinet that a technician can read at a glance from the aisle.

A data centre in Amsterdam replaced metal blanking panels with clear ones across 40 racks. Monitoring walks dropped from a full door open to a glance, and the fire officer then asked for the material data before signing the change off.

Mounting and ventilation on an acrylic rack panel

  • Hole centres: 465 mm, standard 19 inch
  • Panel height: 1U at 44 mm, 2U at 88 mm
  • Vent slots: 6 mm wide, 30 mm pitch, ends radiused
  • Edge: 2 mm radius, no sharp corner in an aisle

Vent slots are the part that gets cut too aggressively. A row of slots with square ends becomes a crack starter when the panel is removed and refitted, and radiused ends cost nothing to add at the cutter.

Fire specification and material choice

acrylic rack panel covering a network cabinet with visible equipment

Cast acrylic burns, and a comms room specification may rule it out. Where a clear face is wanted and the standard is strict, the usual answer is a metal panel with an acrylic window, which keeps the view and leaves the fire performance to the frame.

Service access and labelling

A clear panel with a printed label strip near the top lets a technician identify a rack without opening it. Labels printed on the inner face stay legible and do not peel at the edge where a hand brushes past.

Cutting and hole placement for panels like this is covered in acrylic sheet cut to size.

Send your rack unit count, equipment layout and fire requirements to oversales@rpplexiglass.com for a panel quotation.

Frequently Asked Questions

Is acrylic acceptable inside a rack?

Often, but check the site fire specification first. Standard cast acrylic is combustible, and a comms room with a strict fire standard may require a rated material or a metal panel with a window.

How are mounting holes spaced?

On the standard 465 mm hole centres for a 19 inch rack, with the panel cut to a 1U or 2U height. Hole positions come from the rack, not from a drawing.