Acrylic Tissue Culture Vessel: Lab Build

An acrylic tissue culture vessel is specified by three numbers before anything else is discussed: air exchange rate at the filter patch, light transmission through the wall, and the sterilisation route the lab actually runs. Get the third one wrong and the box is scrap within a month.

Most enquiries start with a photograph of an imported box and a request to copy it. The copy usually fails on the vent, because the original was designed for a gamma line and the buyer runs an autoclave.

Vent, gas exchange and the acrylic tissue culture vessel

  • Vessel: 100 x 100 x 80 mm, 4 mm walls, 5 mm base
  • Vent: 25 mm port with 0.2 micron PTFE filter patch
  • Light transmission: 92 percent at 3 mm, ISO 13468
  • Lid clearance: 1.5 mm, gasket free
acrylic tissue culture vessel holding plantlets in a laminar flow cabinet

A sealed acrylic box with no vent accumulates ethylene and water vapour within a week, and plantlets abort. A 25 mm patch vent on the lid, positioned away from the lamp side, fixes both without a filter housing.

Sterilisation and the acrylic tissue culture vessel

Cast PMMA has a glass transition near 105 C and a heat deflection close to 95 C, so an autoclave cycle at 121 C is out of the question. Gamma at 25 kGy is the standard route and leaves the wall clear. Chemical disinfection with 70 percent alcohol is tolerated for wiping, but repeated soaking crazes the surface.

Condensation under growth lighting

Condensation on the lid is a lighting problem more than a material one. A 2 degree tilt on the rack sends the water to one corner instead of forming a lens over the plantlets, and it costs nothing to build into the shelf.

River People supplies vessels, vented lids and racks cut to your footprint, with patch filters fitted on request. Specifications go to oversales@rpplexiglass.com.

Send the vessel footprint, vent size and sterilisation method to oversales@rpplexiglass.com for a quotation on boxes, lids and racks.

Labs that also run a fume hood will find the sash detail in our polycarbonate lab hood sash guide.

Frequently Asked Questions

Can an acrylic tissue culture vessel be autoclaved?

No. Cast PMMA softens near 100 C and a 121 C cycle distorts the box and crazes the walls. Gamma irradiation at 25 kGy or chemical disinfection are the compatible routes.

Why choose acrylic over polycarbonate?

Clarity and no yellowing under fluorescent growth lighting. Polycarbonate is the right choice only where the lab insists on steam sterilisation.

Which wall thickness is typical?

4 mm for 100 mm cube vessels, 5 mm above 150 mm, with a 6 mm lid to resist clamping.