Three calls in a week, same story with a different shop: the acrylic sign holder a4 will not take the leaflet. In each case the holder had been cut to the exact paper size and the print had been trimmed after bleed to 213 x 300 mm. The holder was correct to a drawing and useless in a store.
The fix is not more precision, it is deliberate clearance.
Insert clearance in the acrylic sign holder a4
- Cut opening: 216 x 302 mm for a 210 x 297 mm sheet
- Width clearance: 3 mm total, split on both sides
- Height clearance: 5 mm, so the sheet drops in without pinching
- Front panel: 2 mm cast, back panel 2 mm cast, 4 mm gap
- Base: 10 mm block, 60 mm deep, for counter units
A holder cut tight also fails a second way. A sheet that has to be pressed in scratches the inner face on the way down, and the scratch shows through the front panel under shop lighting. Clearance solves the fit and the finish in one change.
Base weight and the acrylic sign holder a4 on a counter
A counter unit is moved by every person who leans on the counter. A 2 mm folded foot carries too little contact area and slides; a 10 mm solid base block of 60 mm depth keeps a 300 mm tall holder stable against a light knock. Where the counter is glass, add a 1 mm closed cell foam pad, because a bare acrylic base will mark laminated glass over a season of sliding.
Print, glare and the acrylic sign holder a4 surface
Cast acrylic at 2 mm passes about 92 percent of visible light, which is why a matte print reads well inside it. The failure mode is reflection: a glossy print behind a clear front panel doubles the glare under downlights. A matte front panel or an anti glare coated sheet removes most of it, at roughly 15 percent cost.
River People produces holders to your insert and print size, portrait or landscape, with polished edges and base blocks matched to the counter. Sizes and quantities go to oversales@rpplexiglass.com.
Send the insert size, orientation and quantity to oversales@rpplexiglass.com for a quotation with one sample holder per size.
Counter units with a different insert format are covered in acrylic menu holder builds for hospitality counters.
Frequently Asked Questions
Why does a printed A4 sheet jam in a holder?
Because the holder is cut to 210 x 297 mm exactly and the print is trimmed to 213 x 300 mm after bleed. A holder needs 3 mm clearance on width and 5 mm on height.
Which thickness suits a counter unit?
3 mm front and back with a 10 mm base block. A 2 mm holder is fine against a wall but flexes when a customer lifts it to read.
Should the base be a separate block?
Yes for counter units. A folded base at 2 mm thickness tips when the holder is touched, and the folded corner crazes within a few months.
