A dining table is a hostile place for a printed object: drinks spill, cards are picked up with wet fingers and a table is cleared in seconds, which is why an acrylic table card is a structural choice before it is a print job.
A restaurant group in Lisbon ordered 350 table cards for a seasonal menu change. The printers delivered 300 gsm cards that measured 4 mm thick when laminated, and the 3 mm slots on the acrylic holders could not take them.
Slot and card fit on an acrylic table card
- Card stock up to 2 mm: 3 mm slot
- Laminated card 3 to 4 mm: 5 mm slot
- Bottom clearance: 3 mm
- Slot mouth: chamfered 1 mm
The mismatch between card stock and slot is the single most common ordering error, because the card is specified by the printer and the holder by the fabricator, and neither sees the other drawing.
Reading angle and table geometry
A tent at 65 degrees puts the first line of the card in the view of both diners without either leaning. Steeper tents look better in a photograph and worse at the table, and a diner sitting close to a square edge notices that too.
Edges within arm reach
- Round every edge within 200 mm of a seat
- Flame polish or diamond finish, no sawn face
- Base footprint wider than the card width
- No sharp corner at the tent apex
Cleaning and print replacement
Cards are replaced seasonally while the holder stays for years, so the slot is the part that has to survive handling. A holder with a chamfered slot mouth and a rounded apex still accepts a card after hundreds of changes.
Tent geometry is compared in the acrylic table tent guide for restaurants that use both formats.
Send your card size, table count and print artwork to oversales@rpplexiglass.com for a quotation.
Frequently Asked Questions
What tent angle reads best from a table?
Between 60 and 70 degrees from the table surface. Flatter angles need a diner to lean forward, steeper ones hide the top line of the card from the opposite seat.
How much clearance for the printed card?
0.5 to 1 mm on each side and 3 mm at the bottom. A card pressed into the slot bows and lifts at the centre, which shows as a shadow under the print.
Does the card need weight?
A 5 mm base on a small tent is enough. Tall narrow cards tip in a draught or when a menu is taken out of the slot, so the base is widened rather than thickened.
