Acrylic Guitar Display Case: Music Store

A music store display case is a viewing box with a 4 kg object inside, and an acrylic guitar display has to carry that object without touching the finish while letting a customer see the top at eye level.

A vintage guitar dealer in Tokyo commissioned two cases for instruments valued above the cost of a car. The first unit hung the guitars from the headstock, and after six months both instruments showed relief changes that the dealer attributed to the suspension.

Load path in an acrylic guitar display case

Body cradle

  • Cradle: shaped to the lower bout, 2 contact lines
  • Cradle depth: 25 mm, felt lined
  • Neck rest: at the 7th fret position
  • Base: 10 mm, wider than the case footprint

A cradle that follows the lower bout spreads the load across two lines and leaves the back of the instrument free. A flat shelf point loads the body and marks a lacquered back within a season.

Wall thickness where hands press

Panels inside 600 mm of a support can be 6 mm. A tall unsupported face that customers lean on needs 10 mm, and the joints at that face are bonded with a reinforcing strip rather than a plain butt seam.

Humidity, light and finish

acrylic guitar display case holding an electric guitar in a shop

A sealed case in a humid shop is a condensation trap, and a lacquered top marks permanently. Two vents, low and high, let air move while keeping dust out, and an LED strip outside the case avoids heating the interior.

Case interiors for high value objects are discussed in museum display case glazing.

Send the instrument dimensions, stand height and quantity to oversales@rpplexiglass.com for a case quote.

Frequently Asked Questions

Which thickness for a guitar case wall?

6 mm for a wall panel within 600 mm of a support, 10 mm for an unsupported span or a unit that gets leaned on. Instrument weight is not the issue; a hand pushing on the panel is.

How should the guitar be supported?

A body cradle plus a neck rest. Hanging the instrument from the headstock puts the whole load on the truss rod area, and a case that must survive years of display should carry the body.

Does the case need ventilation?

Yes, at least two 20 mm vents low and high. A sealed case in a humid shop collects condensation on a lacquered top, and the marks left behind are permanent.