Wafer carriers are specified by slot count and wafer diameter, then judged by a particle count that nobody reads until a yield drop. The gap between those two views is where most acrylic wafer carrier projects go wrong.
Start with the numbers that hold regardless of tool.
Slot pitch and the acrylic wafer carrier stack
- 150 mm wafers: 4.0 mm pitch, 2.5 mm land, 25 slot standard
- 200 mm wafers: 4.8 mm pitch, 3.0 mm land, 25 slot standard
- Plate: 6 mm cast for a 13 slot carrier, 8 mm above 25 slots
- Rib height: 12 mm, contact on the wafer edge only
- Base clearance: 15 mm, so a fork can enter without touching a wafer
The 4.8 mm figure for 200 mm wafers exists because a robot end effector needs about 2 mm of vertical clearance to slide under the wafer without lifting the stack. Below that the transfer becomes a scrape, and a scraped edge is a scrapped wafer.
Edge contact and the acrylic wafer carrier geometry
Contact should be a line on the wafer edge, not a face. A rib that touches the polished face introduces a scratch risk on every insertion, and the scratch is not visible until inspection. A 12 mm rib at the edge, with a 0.5 mm chamfer on the leading face, keeps contact where the wafer is already unpatterned.
Cleaning and the acrylic wafer carrier release
A new carrier goes through a wash in DI water, an IPA rinse and a nitrogen dry before it is allowed near a tool. Cast acrylic resists IPA and does not craze at ambient temperature, which is why it holds up in a wet bench environment where polycarbonate would stress crack within weeks.
River People machines carriers to your slot pattern with edge-only contact geometry and particle test records per batch. Send the wafer diameter and cleanroom class to oversales@rpplexiglass.com.
Send the wafer diameter, slot count and cleanroom class to oversales@rpplexiglass.com for a quotation with one carrier for particle testing.
Carriers move between areas, and the glazing at each transfer point is set out in cleanroom partition glazing.
Frequently Asked Questions
Does cast acrylic meet a cleanroom particle spec?
Only after cleaning and outgassing. Cast sheet carries residual monomer and cut dust in the slots, so a carrier is washed, dried and baked before it is released to a classified area.
What slot pitch suits 200 mm wafers?
4.8 mm pitch for an 8 mm wafer stack, with a 3 mm land between slots. Tighter pitch raises the risk of a wafer touching its neighbour during transfer.
Is antistatic acrylic available?
Yes as a coated or volume conductive sheet, though cast clear is the default where grounding is handled by the tool rather than the carrier.
