A produce packer was losing about 1.5 percent of PETG food trays to rim cracks before filling, and the loss doubled in winter when the packing hall dropped below 15 C.
The sheet was fine and the tool was fine. The PETG food tray was being formed and trimmed cold, and a cold trimmed rim is where every crack starts.
Draw, rim and the PETG food tray
- Shallow tray: 0.8 mm, draw to 25 mm
- Deep tray: 1.5 mm, draw to 60 mm, ratio under 2.0
- Rim: 6 mm radius, trimmed warm
- Nesting: 30 mm pitch for pallet stability
Draw ratio is the number to respect. A 1.0 mm sheet drawn to 60 mm in a 100 mm pocket finishes at about 0.55 mm on the wall, which is thin enough to collapse under a stacked load.
Cold, food contact and the PETG food tray in a chilled chain
Below 15 C PETG loses impact strength quickly. A tray formed warm and packed cold is fine; a tray formed and trimmed cold is not, and the difference shows as rim cracks rather than wall failure.
Documentation for food contact
Buyers increasingly ask for a declaration of compliance rather than a data sheet. The sheet grade has to be specified at order, and the forming shop has to keep the lot traceable.
River People forms trays from food contact PETG with warm trimming and nesting to your pallet plan. Send the tray drawing and fill weight to oversales@rpplexiglass.com.
Send the tray drawing, fill weight and annual volume to oversales@rpplexiglass.com for a quotation on formed trays and tooling.
Formed trays and cut sheet often ship together, and the PETG sheet cut to size note covers tolerance and packing for both.
Frequently Asked Questions
Is PETG suitable for direct food contact?
Food contact grades are available and should be specified explicitly. Recycled or industrial PETG is not a food contact material.
What draw ratio can PETG take?
Up to about 2.0 for shallow trays. Above that the walls thin unevenly and the rim distorts.
Why do trays crack at the rim?
Rim cracking comes from a sharp trim and cold forming. A radiused trim and a warm tool remove it.
