Polycarbonate Boat Hatch: Deck Opening

Polycarbonate boat hatch lids are the one clear panel on a yacht that a crew member stands on, so the material is chosen for foot traffic and the seal for boarding seas.

A charter fleet in Split replaced eight hatch lids in one season. The lids had been cut at 8 mm from an uncoated sheet, and the deck side face had hazed so badly that the skipper could not see the engine room below.

Deck load and thickness on a polycarbonate boat hatch

  • Opening up to 600 mm: 10 mm
  • Opening above 600 mm: 12 mm
  • Camber: match the deck, do not flatten
  • Surface: hard coated both faces

A person stepping onto a lid puts a point load in the middle of the panel, and deck camber decides where that point sits. Cutting a flat lid into a cambered deck opening forces the gasket to take a gap.

Gaskets, hinges and the strut

polycarbonate boat hatch cover on a yacht deck

The gasket needs about 30 percent compression to seal, which means a latch that pulls the lid down rather than one that just holds it shut. A gas strut sized for the lid weight stops the lid dropping onto fingers.

Haze, abrasion and the long term deck view

A hard coated polycarbonate keeps its clarity against foot traffic and salt. The edge of the lid should be sealed as well as the face, because water entering the core is what turns a clear panel milky from the inside.

Boarding spray and windscreen sealing is covered in polycarbonate boat windshields.

Send your opening size, deck camber and quantity to oversales@rpplexiglass.com for a quotation.

Frequently Asked Questions

Which thickness for a walk on hatch?

10 mm for an opening under 600 mm and 12 mm where the lid is walked on or spans above 600 mm. Deck load is a person, not a wave.

How is the seal made watertight?

A closed cell gasket compressed about 30 percent by a cam latch or a screw clamp. A gasket that merely touches will leak as soon as the deck is awash.

Does polycarbonate handle UV on deck?

A UV stabilised grade does for years, and a hard coated face resists the abrasion that comes with a lid being walked on. Uncoated sheet on a sun deck hazes far sooner.