Polycarbonate Police Car Partition: Cab

Polycarbonate police car partition panels are chosen for what happens in the rear seat during a shift, and the number that sets the specification is the kick load rather than the crash standard alone.

A regional fleet in Queensland rebuilt 30 partitions after officers reported rattling at highway speed. The cause was a panel cut to the cabin width and clamped at two edges, leaving it free to flex.

Thickness and frame in a polycarbonate police car partition

A panel that is held, not clamped

  • Thickness: 8 mm saloon, 12 mm van
  • Frame: aluminium with a rubber isolator
  • Edge grip: continuous, four sides
  • Ventilation: louvre at head height

A continuous frame with a rubber isolator stops the panel from drumming and spreads a kick load around the edge instead of into two bolts. The isolator also absorbs shell flex on rough roads.

Ventilation, seal and the rear compartment

polycarbonate police car partition between front and rear seats

Air has to move between front and rear without a hand sized gap. A louvred opening at head height with a mesh insert gives the airflow and keeps the panel structurally continuous.

Cleaning a surface that is touched all shift

Partitions are wiped with disinfectant after every transport, which is why a hard coated face matters. An uncoated sheet crazes in months under that routine and starts to look cloudy from the driver seat.

Threat level and build up selection for vehicle glazing is covered in hard coated polycarbonate sheet.

Send your vehicle model, partition layout and fleet size to oversales@rpplexiglass.com for a quotation.

Frequently Asked Questions

Which thickness for a vehicle partition?

8 mm for a saloon car partition and 12 mm for a van or a wagon where the panel is larger and the rear space is used for equipment.

Why polycarbonate rather than glass in a car?

Kicks, equipment thrown from the rear and crash loads all favour a material that deforms rather than shatters. Glass in a patrol car is a projectile risk.

How is the partition ventilated?

Through a louvred opening at the top or a dedicated duct, not by leaving a gap at the edge. An edge gap is a hand hold and a draught at the same time.