Polycarbonate Lab Hood Sash: Fume Safety

A fume cupboard sash is the one component a chemist touches every few minutes, and a polycarbonate lab hood sash is chosen for impact resistance and weight, with the chemical exposure at the frame edge checked before anything is ordered.

A teaching laboratory in Leeds replaced 12 glass sashes after two breakages in a term. The polycarbonate replacements halved the sash weight, and the counterbalance springs then needed resetting because the sashes rose too fast.

Weight and counterbalance on a polycarbonate lab hood sash

  • Thickness: 6 mm for a hood under 1200 mm wide
  • 8 mm for wider sashes and high use teaching labs
  • Counterbalance: reset for the new sash weight
  • Edge: 10 mm clear margin to the frame

Half the weight of glass changes the feel of the sash, and a spring set for glass lets a polycarbonate sash snap up. The spring is adjusted to the new panel before the hood is returned to service.

Chemical exposure at the edge

polycarbonate lab hood sash in a fume cupboard of a laboratory

Solvent vapour attacks the bond line and the frame edge faster than the face. A sash with a clear margin between the chemical zone and the frame, and a frame gasket that is checked for compatibility, lasts longer than one where the panel runs into the fume path.

View quality at full opening

A sash that is heavily tinted or scratched reduces the working view and pushes users to work with the sash higher than they should. Optical clarity is a safety property in a hood, not a cosmetic one.

Cut tolerances for replacement panels are set out in polycarbonate cut to size.

Send your hood model, sash dimensions and quantity to oversales@rpplexiglass.com for a sash quotation.

Frequently Asked Questions

Which material suits a fume hood sash?

Polycarbonate where impact and moving parts dominate, provided chemical exposure is checked. Glass resists solvents better; polycarbonate wins on weight, breakage and replacement cost.

How heavy is a polycarbonate sash?

Roughly half the weight of a laminated glass sash of the same size, which matters for the counterbalance springs and for the force needed to lift it.

Can a sash be retrofitted to an old hood?

Usually yes. The sash is cut to the existing frame and the counterweight or spring is checked against the new weight before the panel is fitted.