Polycarbonate Car Wash Bay Panel

A polycarbonate car wash bay panel is a sales surface as much as a barrier: the customer sees it from the driver seat while the car is being cleaned. A panel that has gone milky from water marks makes a modern site look neglected.

The specification below came out of a chain upgrading 18 sites, where the previous dividers were 5 mm acrylic and had cracked at the frame edge on almost every bay within two years.

Jet pressure and the polycarbonate car wash bay panel

A bay lance runs 80 to 120 bar at 200 to 300 mm stand off. Polycarbonate absorbs that without damage, provided the jet is not parked on one spot. The failure mode is erosion at a fixed point, usually where an operator rests the lance while talking.

  • Divider panel: 6 mm, rails at 800 mm centres
  • Wide bay: 8 mm with a mid rail
  • Frame: aluminium with EPDM gasket, drained at the base
  • Edge: machined square, protective film removed at handover
polycarbonate car wash bay panel separating wash bays

Rails at 800 mm keep a 2 m panel from waving under jet impact. A single top and bottom rail on the same span produces a visible ripple that customers read as a cheap installation.

Water marks, seals and the polycarbonate car wash bay panel

Marks form on the inner face where water collects and dries. A sealed frame with a 2 mm fall toward a base drain removes most of that, and a monthly wipe with a soft cloth and detergent handles the rest.

The detail that stops frame edge cracks

Cracks at the frame edge come from tight fixings and thermal movement. Holes 2 mm oversize with sealing washers, and no silicone between pane and gasket, let the panel move as the bay heats and cools through the day.

River People cuts bay panels to your divider drawings, with gaskets and edge trim supplied and panels crated upright. Send the bay size and jet pressure to oversales@rpplexiglass.com.

Send your bay dimensions, jet pressure and layout to oversales@rpplexiglass.com for a quotation on bay panels with frame kits.

Bay dividers and shelter panels face the same wet public duty, and the polycarbonate bus shelter panels sets out frame and gasket practice for both.

Frequently Asked Questions

Will a pressure washer damage polycarbonate?

At normal bay pressure up to 120 bar and 200 mm stand off, no. A jet held at the same spot close to the surface can gouge the sheet.

Why does the panel look dirty from the outside?

Water marks on the inner face. Sealed panels with a slight fall and a drain detail stay clear far longer than open frames.

What thickness for a 2 m wide divider?

8 mm with a mid rail, or 6 mm with rails at 800 mm centres. Without a mid rail a 2 m span waves visibly when a jet hits it.