Blocked chutes are usually discovered by a sensor or by the plant stopping. A clear liner changes that: the operator sees product building at the transition before it becomes a blockage. That is the argument that sells a polycarbonate chute liner on grain and food lines.
On abrasive duties the argument is different. A liner of the right polymer takes the wear instead of the steel shell, and it can be replaced in a shutdown rather than welded.
Sliding angle and the polycarbonate chute liner
Polycarbonate on damp grain slides at about 35 degrees. Below 30 degrees the product starts to stick on the polished face, especially in humid weather, and a stuck layer accelerates wear at the edges.
- Grain and pellets: 8 mm liner, 35 degree minimum slope
- Light aggregate: 10 mm liner, 40 degree minimum slope
- Fixing pitch: 60 mm, 40 mm from edges
- Holes: 2 mm oversize with bonded sealing washers
Impact points take the worst of it. Where the stream lands, a thicker sacrificial pad or a curved entry section spreads the load over a larger area, and that detail usually doubles liner life.
Fixing, thermal movement and the polycarbonate chute liner
Polycarbonate expands about 3 mm per metre over a 60 C swing. Liners bolted tight at both ends buckle in the middle when the chute warms, so the fixing pattern leaves one end free to slide in slotted holes.
When UHMWPE is the better liner
UHMWPE has lower friction and better abrasion resistance for sharp rock, but it is opaque and softer under point impact. For crushed stone above 50 mm, specify UHMWPE; for grain, pellets and food products where visibility matters, polycarbonate is the practical choice.
River People cuts liners to your chute development drawing, drills to the fixing pattern and ships flat for site rolling. Send the chute geometry and product to oversales@rpplexiglass.com.
Send your chute drawing, product type and throughput to oversales@rpplexiglass.com for a quotation on cut and drilled chute liners.
Abrasion decides liner life, and our polycarbonate surface wear notes explain how surface finish and product shape combine to wear a panel.
Frequently Asked Questions
Does polycarbonate work as a chute liner for aggregate?
For light aggregate and grain, yes. For sharp crushed rock above 50 mm, UHMWPE or steel outlasts polycarbonate because the impact abrasion is too severe.
What fixing pattern avoids cracking?
Holes 2 mm oversize with bonded washers, at least 40 mm from the panel edge and 60 mm apart. Tight holes at the edge crack within weeks.
Why use a clear liner anywhere?
It shows build up and blockage from outside the chute, which is useful on food and grain lines where a blocked chute stops the plant.
