A lathe owner described a polycarbonate machine way cover fault as a paint issue: the saddle paint kept wearing through on one side. The real cause was a missing way cover, with chips packing the front way and the saddle dragging them along.
A polycarbonate machine way cover is a cheap fix for that, and it has one advantage over steel: the operator can see whether the way is oiled without removing anything.
How a polycarbonate machine way cover is built
- Panel: 4 mm for widths to 300 mm, 6 mm above
- Profile: single curved sheet or two piece accordion
- Wiper: 3 mm felt strip along the contact edge
- Fixing: 5 mm slots at the headstock end, not drilled holes
Slots rather than holes let the cover slide as the carriage moves, and they stop the panel cracking at a fixing when the machine warms up. Holes are the single most common crack origin on these parts.
Coolant, chips and the polycarbonate machine way cover in service
Water based coolant at 5 to 8 percent concentration is harmless to polycarbonate. Neat cutting oil, some synthetic esters and chlorinated additives soften the surface, and a softened cover picks up chips and becomes opaque within a year.
Chip load is the other limit. A cover sitting 20 mm above the way deflects a stream of chips away from the sliding surface, which is enough for turning and light milling. Heavy interrupted cutting throws chips hard enough to erode any polymer, and those machines should keep steel.
The wiper that keeps it tracking
A 3 mm felt wiper along the moving edge stops chips running under the panel and keeps the cover tracking parallel to the way. Without it, the cover skews and the leading corner digs into the paint.
River People cuts and bends way covers to your machine travel and width, with wiper strip fitted and edges trimmed. Send the machine model and carriage travel to oversales@rpplexiglass.com.
Send the machine model, travel length and cover width to oversales@rpplexiglass.com for a quotation on cut and formed way covers.
Where chips and coolant both hit the panel, our hard coated polycarbonate for machine guards notes explain when a hard coat earns its cost.
Frequently Asked Questions
Is polycarbonate resistant to cutting coolant?
Most water based coolants are fine. Neat oils and some synthetic esters soften the sheet over years, so specify the coolant before ordering.
What thickness for a lathe way cover?
4 mm for widths under 300 mm, 6 mm above that. A 4 mm cover over 400 mm flutters with the carriage and rubs the paint off the saddle.
Can a clear cover replace a steel telescopic cover?
For light chip load, yes, and it shows the way oil film. For heavy interrupted cutting, steel remains the right choice because chips at speed erode any polymer.
