A metro station surveyed its polycarbonate escalator balustrade panels after 18 months in service and found the panels sound but the appearance unacceptable: two of six runs had gone from clear to a grey haze. Trolley bags and cleaning cloths had done the work that a scratch test never predicts.
In a public circulation space, polycarbonate escalator balustrade panels are judged by appearance at least as much as by containment.
Thickness, frame and the polycarbonate escalator balustrade
- Free span panel: 10 mm, hard coated both faces
- Framed panel with mid rail: 8 mm
- Handrail clearance: 50 mm from panel face
- Edge: machined and polished, film removed at handover
A free span panel deflects under a leaning passenger and that deflection is what the fixing design has to absorb. Eight millimetre sheet in a mid railed frame is stiffer because the frame carries the load, not the panel alone.
Cleaning, inspection and the polycarbonate escalator balustrade
The two failure points after a year are the handrail clearance line, where cleaning cloths rub, and the bottom fixing, where water and grit collect. Both are visible in a walk round with a torch.
What a station should check quarterly
Crazing at fixings, haze on the inner face, and gasket compression at the base. A panel that has started to craze at a fixing hole is still safe but should be scheduled rather than left to fail in service.
River People cuts and finishes balustrade panels to the existing frame drawing with both faces hard coated. Send the escalator model and panel schedule to oversales@rpplexiglass.com.
Send the escalator model, balustrade length and existing frame drawing to oversales@rpplexiglass.com for a quotation on panels.
Balustrade panels are cut to a frame schedule, and the polycarbonate panel cutting service page covers edge finish and packing for long panels.
Frequently Asked Questions
Can polycarbonate replace tempered glass on a balustrade?
It can where the local code allows a polymeric balustrade panel, and the frame and handrail fixings must be designed for the panel stiffness.
How is scratching managed in a station?
Hard coated panels on both faces, plus a cleaning schedule with a wet cloth. Uncoated panels in a station look frosted within a year.
What thickness for a 1.1 m balustrade?
10 mm for a free spanning panel, 8 mm where the panel sits in a full height frame with a mid rail.
